Buscar
Mostrando ítems 11-20 de 462
Computational support for the process of software requirement specification
(Ieee, 2012-01-01)
The software industry has become more and more concerned with the appropriate application of activities that composes requirement engineering as a way to improve the quality of its products. In order to support these ...
A software development process model for gesture-based interface
(2012-12-01)
Gesture-based applications have particularities, since users interact in a natural way, much as they interact in the non-digital world. Hence, new requirements are needed on the software design process. This paper shows a ...
Mathematical models to optimize lateral line length using two spacing between drippers
(2014-01-01)
In drip irrigation systems, longer lateral lines can provide cost reduction, but it is limited by the required irrigation uniformity. Non-pressure compensating drip hose is widely used for vegetables and orchards irrigation ...
The improvement in grinding of inlet engine valves by the adoption of the most effective cuting fluid type
(2000-12-01)
In this paper is presented an experimental research in which the grinding of seating surfaces of inlet engine valves was improved by the adoption of the most effective cutting fluid type, matching the new requirements of ...
Design Aspects Applied to Engineering: Technology Sustainable Development and Innovation in the Science Parks
(Springer, 2016-01-01)
Science Parks are sustainable environments where design, aligned with engineering, can achieve its maximum concept by linking scientific research and practical application. This action can facilitate implementation of new ...
Optimization of automotive components using the variational technology
(2004-01-01)
In a traditional finite element analysis, any change in the parameters that define the geometry or the physic properties requires a new analysis run in order to check the component performance. This can be a limitation in ...
Variable Compression Ratio Engines
(, 2009)
Using Constructive Learning In Embedded Systems Engineering
(IEEE, Piscataway, NJ, United States, 1998)