Buscar
Mostrando ítems 1-10 de 13
Clamp bending machine and annealed wire cutter for reinforced concrete columns
(Institute of Physics Publishing, 2020-02-28)
This study developed a reinforced steel rod bending machine for rods with diameters of up to 8 mm and annealed wire cutter for up to 5 kg for replacing manual intervention required to bend rods in reinforced concrete ...
Clamp bending machine and annealed wire cutter for reinforced concrete columns
(Universidad Continental, 2020-02)
This study developed a reinforced steel rod bending machine for rods with diameters of up to 8 mm and annealed wire cutter for up to 5 kg for replacing manual intervention required to bend rods in reinforced concrete ...
Clamp bending machine and annealed wire cutter for reinforced concrete columns
(Universidad ContinentalPE, 2020)
This study developed a reinforced steel rod bending machine for rods with diameters of up to 8 mm and annealed wire cutter for up to 5 kg for replacing manual intervention required to bend rods in reinforced concrete ...
Tube bending improvement for bogbi bicycles using JD-32 manual bending machine
(Universidad de los AndesIngeniería MecánicaFacultad de IngenieríaDepartamento de Ingeniería Mecánica, 2018)
En este trabajo se estudió el doblaje de un tubo de acero inoxidable 304 para un tubo con diámetro de 1.5 pulgadas, con el deseo de mejorar los resultados generando un doblaje uniforme y estándar para la máquina de doblar ...
OPTIMIZACIÓN DE DISPOSITIVO DE SUJECIÓN PARA ENSAYOS BIOMECÁNICOS EN VÉRTEBRAS
(2011-06-13)
In this work it is proposed a clamping device for biomechanical testing in vertebrae to
realize biomechanical testing applying loads of compression, flexion, torsion or any combination
of them.
It was realized an ...
Fretting fatigue in overhead conductors: Rig design and failure analysis of a Grosbeak aluminium cable steel reinforced conductor
(PERGAMON-ELSEVIER SCIENCE LTD, 2009)
The performance optimisation of overhead conductors depends on the systematic investigation of the fretting fatigue mechanisms in the conductor/clamping system. As a consequence, a fretting fatigue rig was designed and a ...
Diseño y construcción de una máquina para rolar de tubos cuadrados y redondos en la metal-mecánica “CAISA”.
(Ecuador: Latacunga: Universidad Técnica de Cotopaxi (UTC)., 2020)
Diseño y construción de una máquina para ensayos de resistencia a la fatiga mecánica por flexión en probetas de polímeros impresos en 3D
(Escuela Superior Politécnica de Chimborazo, 2020-09-21)
In this titling work, the objective of designing a machine for testing resistance to mechanical fatigue by rotary bending was set and its subsequent construction with the low-cost modality to test in specimens based on ...
Análisis de la estabilización segmentaria en especímenes de columna lumbar porcina (L2-L5) con cerclaje interespinoso, empleando cinturones depoliamida 6/6
(2018-05-04)
RESUMEN: El presente trabajo se evaluó el problema de la artrosis facetaria en la región lumbar enfocada a pacientes mexicanos empleando cinturones de poliamida 6/6 para la estabilización segmentaria de L2-L4. Como una ...