dc.contributorUcañani Ascue, Nancy Elizabeth
dc.creatorTipián Ortiz, Daniel Alexander
dc.date.accessioned2024-03-19T16:06:36Z
dc.date.accessioned2024-05-09T20:05:59Z
dc.date.available2024-03-19T16:06:36Z
dc.date.available2024-05-09T20:05:59Z
dc.date.created2024-03-19T16:06:36Z
dc.date.issued2023-12-18
dc.identifierhttps://hdl.handle.net/20.500.12557/6143
dc.identifier.urihttps://repositorioslatinoamericanos.uchile.cl/handle/2250/9394129
dc.description.abstractEste estudio tuvo como Objetivo: Determinar las variaciones anatomo- imagenológicas del foramen mandibular a los bordes de la rama ascendente de la mandíbula en tomografías cone beam. Materiales y métodos: Se realizó un estudio no experimental, descriptivo, retrospectivo, transversal, y observacional, se consideraron 70 tomografías del área de radiología y Diagnóstico por imágenes del CEU “Luis Vallejo Santoni”, los cuales cumplieron los criterios de selección establecidos por este estudio. Resultados: Los resultados de este fueron que las variaciones anatomo-imagenológicas del foramen mandibular en la longitud de dicho foramen a los bordes de la rama ascendente de la mandíbula de ambos lados fueron: Borde anterior 18,45 mm; borde posterior 12.92 mm; borde superior 21,16; borde inferior 27,31 mm y que, en sentido anteroposterior u horizontal el foramen mandibular se encontró más cerca al borde posterior, mientras que en el sentido superoinferior o vertical el foramen mandibular se encontró más cerca al borde superior. Conclusiones: La conclusión establece que, en términos horizontales (de adelante hacia atrás) el foramen mandibular se encuentra más próximo al borde posterior, mientras que en términos verticales (de arriba hacia abajo) se halla más próximo al borde superior.
dc.description.abstractThis study had as Objective: This study aimed to determine the anatomical and radiological variations of the mandibular foramen in relation to the borders of the ascending ramus of the mandible using cone beam tomography. Materials and Methods: A non-experimental, descriptive, retrospective, cross-sectional, and observational study was conducted, involving the analysis of 70 cone beam tomographies from the Radiology and Diagnostic Imaging Department at "Luis Vallejo Santoni" University. The selection of tomographies adhered to the established criteria for this research. Results: The study revealed that anatomical and radiological variations of the mandibular foramen in terms of its length to the borders of the ascending ramus of the mandible on both sides were as follows: Anterior border 18.45 mm, posterior border 12.92 mm, superior border 21.16 mm, and inferior border 27.31 mm. In the anteroposterior or horizontal direction, the mandibular foramen was found to be closer to the posterior border, while in the superoinferior or vertical direction, it was closer to the superior border. Conclusions: In conclusion, in horizontal terms (from front to back), the mandibular foramen is situated closer to the posterior border, whereas in vertical terms (from top to bottom), it is positioned closer to the superior border.
dc.languagespa
dc.publisherUniversidad Andina del Cusco
dc.publisherPE
dc.rightshttps://creativecommons.org/licenses/by-nc-nd/4.0/
dc.rightsinfo:eu-repo/semantics/openAccess
dc.subjectVariaciones anatomo-imagenológicas
dc.subjectForamen mandibular
dc.subjectTomografías cone beam
dc.subjectConducto dentario inferior
dc.titleVariaciones anatomo-imagenológicas del foramen mandibular en tomografías cone beam, Cusco 2023
dc.typeinfo:eu-repo/semantics/bachelorThesis


Este ítem pertenece a la siguiente institución