dc.creatorBicalho, Isabele Cristina
dc.creatorCristina, Isabele
dc.creatorAtaíde, Carlos Henrique
dc.creatorDuarte, Claudio Roberto
dc.date2018-10-22T19:53:33Z
dc.date2018-10-22T19:53:33Z
dc.date2016-02
dc.date.accessioned2023-09-28T20:04:01Z
dc.date.available2023-09-28T20:04:01Z
dc.identifierBICALHO, I. C. et al. Fluid dynamics study of the flow and pressure drop analysis of a non‐Newtonian fluid through annular ducts with unusual cross‐sections. The Canadian Journal of Chemical Engineering, Ottawa, v. 94, n. 2, p. 391-401, Feb. 2016.
dc.identifierhttps://onlinelibrary.wiley.com/doi/abs/10.1002/cjce.22401
dc.identifierhttp://repositorio.ufla.br/jspui/handle/1/31409
dc.identifier.urihttps://repositorioslatinoamericanos.uchile.cl/handle/2250/9043608
dc.descriptionThis paper concerns an experimental and computational study of the laminar flow developed by a pseudoplastic fluid through a partially‐obstructed annulus, considering the effects of eccentricity and inner cylinder rotation. For the eccentric cases the eccentric rotation of the inner tube is applied, which is a novelty in the literature. Pressure drop experimental data are reported for flows of 3 and 9 m3/h of a 1 mg/g xanthan gum aqueous solution through a concentric and a 46 % eccentric annulus with partial obstruction of 6 mm, for cases with and without rotation of the inner cylinder (0 and 400 rpm). Numerical simulations were performed using computational fluid dynamics (CFD) techniques which allowed for reporting of axial velocity profiles, apparent viscosity distribution, and pressure drops for a range of eccentricity values (0, 23, and 46 %) and obstruction heights (0, 6, and 12 mm), which were systematically compared for cases with and without rotation of the inner tube (0 and 400 rpm). Comparisons between numerical calculations and the flow data indicated, in general, very close agreement. Eccentric rotation of the inner cylinder presented a distortion effect on the axial velocity and apparent viscosity profiles for the high eccentricity case (46 %) with high obstruction (12 mm), where two maxima regions were observed, one of them near the inner cylinder.
dc.languageen_US
dc.publisherThe Canadian Society for Chemical Engineering
dc.rightsrestrictAccess
dc.sourceThe Canadian Journal of Chemical Engineering
dc.subjectPartial obstruction
dc.subjectNon‐Newtonian fluids
dc.subjectObstrução parcial
dc.subjectFluidos não newtonianos
dc.titleFluid dynamics study of the flow and pressure drop analysis of a non‐Newtonian fluid through annular ducts with unusual cross‐sections
dc.typeArtigo


Este ítem pertenece a la siguiente institución