México | info:eu-repo/semantics/article
dc.creatorVICTOR IVAN RUIZ PEREZ
dc.creatorJosé Javier Sánchez Mondragón
dc.date2013-04-18
dc.date.accessioned2023-07-25T16:25:10Z
dc.date.available2023-07-25T16:25:10Z
dc.identifierhttp://inaoe.repositorioinstitucional.mx/jspui/handle/1009/2206
dc.identifier.urihttps://repositorioslatinoamericanos.uchile.cl/handle/2250/7807386
dc.descriptionThis research shows the possibility of measuring pressure in the range of 0–7 bar and the comparison against 2 commercial sensors. The technique used is based on the multimodal interference in a fiber optic singlemode–multimode–singlemode (SMS) to 1550 nm. The fiber optic is mounted on a plate of stainless steel AISI 316, where the bending of the plate will generate a curvature on the part of the multimodal fiber generating a decoupling of modes and this generates a low intensity to the output of the system.
dc.formatapplication/pdf
dc.languageeng
dc.publisherOptik
dc.relationcitation:Mejía-Aranda, A. R., et al., (2013). Design of a pressure sensor of 0–7 bar in fiber optic using MMI methodology, Optik, Vol. 124(23):5927-5929
dc.rightsinfo:eu-repo/semantics/openAccess
dc.rightshttp://creativecommons.org/licenses/by-nc-nd/4.0
dc.subjectinfo:eu-repo/classification/Inspec/FOPS
dc.subjectinfo:eu-repo/classification/Inspec/Diaphragm
dc.subjectinfo:eu-repo/classification/Inspec/Multimode interference
dc.subjectinfo:eu-repo/classification/Inspec/Bending
dc.subjectinfo:eu-repo/classification/Inspec/Alternative
dc.subjectinfo:eu-repo/classification/cti/1
dc.subjectinfo:eu-repo/classification/cti/22
dc.subjectinfo:eu-repo/classification/cti/2209
dc.subjectinfo:eu-repo/classification/cti/2209
dc.titleDesign of a pressure sensor of 0–7 bar in fiber optic using MMI methodology
dc.typeinfo:eu-repo/semantics/article
dc.typeinfo:eu-repo/semantics/acceptedVersion
dc.audiencestudents
dc.audienceresearchers
dc.audiencegeneralPublic


Este ítem pertenece a la siguiente institución