info:eu-repo/semantics/bachelorThesis
Half face mask with regulation thermal stability system for continuous air flow: Stabimask
Fecha
2022Registro en:
Pantoja, H., Guerra, M. y Paita, G. (2022). Half face mask with regulation thermal stability system for continuous air flow: Stabimask. Tesis para optar el título profesional de Ingeniero Mecánico, Escuela Profesional de Ingeniería Mecánica, Universidad Continental, Huancayo, Perú.
AIEE 2022: 2022 The 3rd International Conference on Artificial Intelligence in Electronics Engineering
Autor
Pantoja Marin, Helen Jhoana
Guerra Limas, Maycol Nelson
Paita Sulluchuco, Gino Rolando
Institución
Resumen
This article presents the design and prototyping of an electronic
mask as personal protective equipment for the virus pandemic
known as COVID – 19. Needs were identified such as: tightness
and comfort. Requirements for use for long periods of time; this
was considered for the design, also it has an adjustable ventilation
system. The mask was simulated and validated with Solidworks
Flow Simulation software, in addition a PID control model was
implemented, thereby, it was shown that enough flow is gener-
ated to vary the temperature in a range of 20 to 37.2 ° C inside
the mask. The design considers an outlet duct and an inlet duct
with filters that prevent the entry of polluting particles, providing
adequate protection. The prototype was made by 3D printing, And
the thermal stability was achieved with the implementation of the
temperature regulation system. The results obtained were validated,
and they allow to future research to provide greater efficiency to
masks.