dc.contributorAlva Díaz, Luis
dc.creatorArgomedo Medina, Estefany Aracelli
dc.creatorCarbajal Calipuy, Italo Jair
dc.date.accessioned2019-07-18T15:54:08Z
dc.date.accessioned2022-10-24T16:31:45Z
dc.date.available2019-07-18T15:54:08Z
dc.date.available2022-10-24T16:31:45Z
dc.date.created2019-07-18T15:54:08Z
dc.date.issued2019-06-27
dc.identifierArgomedo, E. A., & Carbajal, I. J. (2019). Influencia del tamaño de partícula y tiempo de contacto de la borra de café en la remoción de plomo II de efluente minero, Quiruvilca [Tesis de licenciatura, Universidad Privada del Norte]. Repositorio de la Universidad Privada del Norte. Recuperado de https://hdl.handle.net/11537/21890
dc.identifier628.358 ARGO 2019
dc.identifierhttps://hdl.handle.net/11537/21890
dc.identifier.urihttps://repositorioslatinoamericanos.uchile.cl/handle/2250/4731051
dc.description.abstractSe determinó la influencia del tamaño de partícula y tiempo de contacto de la borra de café en la remoción de plomo II del efluente minero. El estudio experimental se realizó por método de agitación por lotes y la investigación fue bifactorial, evaluando tamaño de partícula en un rango de 850, 425 y 250 µm y diferente tiempo de contacto 30, 60 y 90 minutos con una concentración inicial de plomo de 1.32 mg/l. El resultado del estudio concluyó que la remoción de plomo II (1.32 mg/l) a un tamaño de partícula de 250 µm y tiempo de contacto 90 minutos fue de 87.85%. Las muestras de efluente minero con plomo II fueron analizadas en el laboratorio de Análisis Instrumental de la carrera de Ingeniería Ambiental en la Universidad Privada del Norte; por lo tanto, la influencia del tamaño de partícula y tiempo de contacto de la borra de café sí influye significativamente en la remoción de plomo II. Los resultados mostraron que este método puede utilizarse como una opción de bajo costo.
dc.description.abstractThe influence of the particle size and contact time of the coffee waste in the removal of lead II from the mining effluent was determined.The experimental study was carried out by batch agitation method and the investigation was bifactorial, evaluating particle size in a range of 850, 425 and 250 µm and different contact time 30, 60 and 90 minutes with an initial lead concentration of 1.32 mg/l. The result of the study concluded that the removal of lead (1.32 mg/l) at a particle size of 250 microns and contact time 90 minutes was 87.85%. The samples of mining effluent with lead were analyzed in the instrumental analysis laboratory of the Environmental Engineering career at the Universidad Privada del Norte, using the flame type atomic absorption spectrophotometer equipment. The result was confirmed by the analysis of variance to determine the effect of the relationship between independent and dependent variables. Finally the hypothesis is affirmed, therefore, the influence of particle size and contact time of the coffee waste does significantly influence the removal of lead. The results showed that this method can be used as a low cost option
dc.languagespa
dc.publisherUniversidad Privada del Norte
dc.publisherPE
dc.rightshttps://creativecommons.org/licenses/by-nc-sa/3.0/us/
dc.rightsinfo:eu-repo/semantics/openAccess
dc.rightsAtribución-NoComercial-CompartirIgual 3.0 Estados Unidos de América
dc.sourceUniversidad Privada del Norte
dc.sourceRepositorio Institucional - UPN
dc.subjectMinería
dc.subjectÁtomos
dc.subjectPartículas elementales
dc.titleInfluencia del tamaño de partícula y tiempo de contacto de la borra de café en la remoción de plomo II de efluente minero, Quiruvilca
dc.typeinfo:eu-repo/semantics/bachelorThesis


Este ítem pertenece a la siguiente institución