Tesis
Determinación del módulo de rotura en vigas de hormigón, fabricado con materiales procedentes de la Cantera Ramírez, para fc=28 MPa.
Fecha
2014Registro en:
Ávila Cuatucuamba, Franklin David (2014). Determinación del módulo de rotura en vigas de hormigón, fabricado con materiales procedentes de la Cantera Ramírez, para fc=28 MPa. Trabajo de Graduación previo a la obtención del Título de Ingeniero Civil. Carrera de Ingeniería Civil. Quito: UCE. 210 p.
BIBLIOTECA INGENIERÍA / TICV / 1312
Autor
Ávila Cuatucuamba, Franklin David
Institución
Resumen
El objetivo principal de esta investigación es la determinación del MÓDULO DE ROTURA DEL HORMIGÓN, en base a la flexión en vigas estándar de sección 15x15cm y L=45cm. Para una resistencia de 28MPa., en el diseño del hormigón se consideraron los agregados procedentes de la cantera RAMÍREZ, ubicada en la Parroquia Ambuquí, Cantón Ibarra, Provincia de Imbabura y cemento Selvalegre Plus Puzolánico Tipo IP. Se procedió a determinar las propiedades físicas y mecánicas de cada uno de los agregados, con estos resultados determinar la dosificación de la mezcla de prueba,
aplicando los métodos ACI y DENSIDAD OPTIMA. Se elaboraron muestras representativas de hormigón, las mismas que fueron ensayadas a compresión simple,
resultados que permitieron seleccionar el método más confiable para la realización de
las mezclas definitivas. Con los resultados obtenidos de los ensayos: a flexión en las vigas estándar y a compresión simple a las probetas de hormigón de la mezcla definitiva, se realizaron los respectivos cálculos para determinar: el Módulo De Rotura y el Módulo De Elasticidad Del Hormigón, mediante las expresiones establecidas por el reglamento del ACI comité 318 y 363, resultados que fueron analizados y comparados con los obtenidos experimentalmente. Los ensayos realizados en laboratorio para determinar las propiedades físicas y mecánicas de los agregados, están normados por la ASTM y NTE INEN. The main objective of this research is the determination of the MODULUS OF RUPTURE OF CONCRETE, based on standard flexural beam section L = 45cm and 15x15cm, for a compressive resistance of 28 MPa., in the concrete design were considered aggregates from the quarry RAMIREZ located in Ambuquí Parish, Imbabura Province and cement Selvalegre Plus Type IP Pozzolanic. Were determined and physical and mechanical properties of each of the aggregates; with these results were calculated the dosage of the former test`s mixtures, through ACI method and optimum density. Representative samples of concrete were prepared and then tested to compression, this results allowed select the most reliable final mixtures method. With the experimental of the final mixtures, to flexure in standard beams and compression applied to concrete specimens were determined. The modulus of rupture and the static modulus of Elasticity concrete of the investigated, on the other hand calculation were realized by the standard given by the ACI Committee 318 and 363, which results were analyzed and compared with those obtained experimentally. All the tests performed in the laboratory to determine the physical and mechanical properties of aggregates and cement are regulated by the standards of ASTM and NTE INEN.
Ítems relacionados
Mostrando ítems relacionados por Título, autor o materia.