Artículos de revistas
Influence of the implant diameter with different sizes of hexagon: Analysis by 3-dimensional finite element method
Fecha
2013-08-01Registro en:
Journal of Oral Implantology, v. 39, n. 4, p. 425-431, 2013.
0160-6972
1548-1336
10.1563/AAID-JOI-D-10-00103
WOS:000323804300004
2-s2.0-84883405603
5581364193525500
1239305418355498
Autor
Universidade Estadual Paulista (Unesp)
Renato Archer Information Technology Center
Institución
Resumen
The aim of this study was to evaluate the stress distribution in implants of regular platforms and of wide diameter with different sizes of hexagon by the 3-dimensional finite element method. We used simulated 3-dimensional models with the aid of Solidworks 2006 and Rhinoceros 4.0 software for the design of the implant and abutment and the InVesalius software for the design of the bone. Each model represented a block of bone from the mandibular molar region with an implant 10 mm in length and different diameters. Model A was an implant 3.75 mm/regular hexagon, model B was an implant 5.00 mm/regular hexagon, and model C was an implant 5.00 mm/ expanded hexagon. A load of 200 N was applied in the axial, lateral, and oblique directions. At implant, applying the load (axial, lateral, and oblique), the 3 models presented stress concentration at the threads in the cervical and middle regions, and the stress was higher for model A. At the abutment, models A and B showed a similar stress distribution, concentrated at the cervical and middle third; model C showed the highest stresses. On the cortical bone, the stress was concentrated at the cervical region for the 3 models and was higher for model A. In the trabecular bone, the stresses were less intense and concentrated around the implant body, and were more intense for model A. Among the models of wide diameter (models B and C), model B (implant 5.00 mm/regular hexagon) was more favorable with regard to distribution of stresses. Model A (implant 3.75 mm/regular hexagon) showed the largest areas and the most intense stress, and model B (implant 5.00 mm/regular hexagon) showed a more favorable stress distribution. The highest stresses were observed in the application of lateral load.
Materias
Ítems relacionados
Mostrando ítems relacionados por Título, autor o materia.
-
Effect of axial loads on implant-supported partial fixed prostheses by strain gauge analysis
de Vasconcellos, Luis Gustavo Oliveira; Nishioka, Renato Sussumu; de Vasconcellos, Luana Marotta Reis; Nishioka, Lea Nogueira Braulino de Melo -
Effect of axial loads on implant-supported partial fixed prostheses by strain gauge analysis
Universidade Estadual Paulista (Unesp); Institute of Science Technology - CETEC (2011-11-01)Objectives: The present study used strain gauge analysis to perform an in vitro evaluation of the effect of axial loading on 3 elements of implant-supported partial fixed prostheses, varying the type of prosthetic cylinder ... -
Effect of axial loads on implant-supported partial fixed prostheses by strain gauge analysis
Universidade Estadual Paulista (Unesp); Institute of Science Technology - CETEC (2011-11-01)Objectives: The present study used strain gauge analysis to perform an in vitro evaluation of the effect of axial loading on 3 elements of implant-supported partial fixed prostheses, varying the type of prosthetic cylinder ...