dc.contributorUniversidade de São Paulo (USP)
dc.contributorUniversidade Estadual Paulista (Unesp)
dc.contributorUniversidade Estadual de Campinas (UNICAMP)
dc.date.accessioned2014-05-20T15:28:48Z
dc.date.available2014-05-20T15:28:48Z
dc.date.created2014-05-20T15:28:48Z
dc.date.issued2007-06-01
dc.identifierIEEE Transactions on Applied Superconductivity. Piscataway: IEEE-Inst Electrical Electronics Engineers Inc., v. 17, n. 2, p. 1903-1906, 2007.
dc.identifier1051-8223
dc.identifierhttp://hdl.handle.net/11449/38555
dc.identifier10.1109/TASC.2007.897771
dc.identifierWOS:000248442600213
dc.description.abstractA single-phase superconducting fault current limiter (SFCL) using a 0.9 m length of YBCO coated conductor (CC) tape was tested in 220 V-60 Hz line for fault current up to 1 kA, operating in 77 K. In this work are presented the IN experimental curves measured under DC and AC currents for the electrical characterization of the CC tape in order to design a low voltage current limiter. The experimental setup is described and the test results are presented for a unit conducting a steady nominal AC current of 50 A and also during the fault time (I to 5 cycles.) the performance of the CC-based SFCL providing the limiting resistance developed in the whole tape length after few milliseconds of the beginning of the fault was analyzed.
dc.languageeng
dc.publisherInstitute of Electrical and Electronics Engineers (IEEE)
dc.relationIEEE Transactions on Applied Superconductivity
dc.relation1.288
dc.relation0,408
dc.rightsAcesso restrito
dc.sourceWeb of Science
dc.subjectHTS coated conductor
dc.subjectHTS coils
dc.subjectsuperconducting fault current limiter
dc.titleTest results of a superconducting fault current limiter using YBCO coated conductor
dc.typeArtículos de revistas


Este ítem pertenece a la siguiente institución