Artículos de revistas
Effect of impeller type and stirring frequency on the behavior of an AnSBBR in the treatment of low-strength wastewater
Date
2011Registration in:
BIORESOURCE TECHNOLOGY, v.102, n.2, p.889-893, 2011
0960-8524
10.1016/j.biortech.2010.08.128
Author
CUBAS, Selma A.
FORESTI, Eugenio
RODRIGUES, Jose Alberto D.
RATUSZNEI, Suzana M.
ZAIAT, Marcelo
Institutions
Abstract
The influence of impeller type and stirring frequency on the performance of a mechanically stirred anaerobic sequencing batch reactor containing immobilized biomass on an inert support (AnSBBR - Anaerobic Sequencing Batch Biofilm Reactor) was evaluated. The biomass was immobilized on polyurethane foam cubes placed in a stainless-steel basket inside a glass cylinder. Each 8-h batch run consisted of three stages: feed (10 min), reaction (460 min) and discharge (10 min) at 30 degrees C. Experiments were performed with four impeller types, i.e., helical, flat-blade, inclined-blade and curved-blade turbines, at stirring frequencies ranging from 100 to 1100 rpm. Synthetic wastewater was used in all experiments with an organic-matter concentration of 530 +/- 37 mg/L measured as chemical oxygen demand (COD). The reactor achieved an organic-matter removal efficiency of around 87% under all investigated conditions. Analysis of the four impeller types and the investigated stirring frequencies showed that mass transfer in the liquid phase was affected not only by the applied stirring frequency but also by the agitation mode imposed by each impeller type. The best reactor performance at all stirring frequencies was obtained when agitation was provided by the flat-blade turbine impeller. (C) 2010 Elsevier Ltd. All rights reserved.