Tesis
‘‘ventaja del corte cilíndrico sobre el corte quemado, para el avance lineal en la cortada nw de sección 8’x8’, en roca estructural tipo ii, en la mina charito del proyecto de la compañía minera poderosa s.a.’’
Autor
Torres Sandoval, Marvin Jhomer
Zavaleta Mariños, Willy Walter
Institución
Resumen
The Company Luz del Carmenc SAC has been working of progress in the Charito’s mine a project of Mine´s Company Poderosa SA the cut NW Level 2890 of section 2.40 x 2.40 m, with a structural rock tipe II ( Diorite), the main problem is the linear progress which is lower than projected by blasting, therefore with the purpose of increasing the linear progress, we sought to optimize the influential factors in the progress, between the most important is the cut in the drill pattern. To do this was the implementation of the type of drill pattern with cylindrical cut determined by the calculation methodology proposed by Holmberg according to the schema of cut and the rest of areas, to have data and be able to compare, we carried out the monitoring and control of drilling and blasting by 40 blast with the drill pattern with starting burn cut, I was taking as drilling average length of 2.32m and an average progress of 1.97m; with the drill pattern with starting cylindrical cut and in similar conditions we were made 40 blast achieved a progress of 2.13 m on average, for a drilling length 2.32m.And finally, after the tests carried out in the cut NW was achieved contrasted with the data obtained and spreadsheets the advantage of the drill pattern with starting cylindrical cut on the drill pattern with starting burn cut, which is an increase in 7.1% of linear progress by blasting, the reduction of the power factor of 0.14 Kg/tn by blasting and the decrease in costs per linear meter of 13.52% La contrata Luz del Carmenc SAC viene realizando trabajos de avance en la mina Charito proyecto de la Compañía Minera Poderosa SA trabajando en la cortada NW Nv. 2890 de sec.2.40 x 2.40 m con una roca estructural tipo II (Diorita), siendo su principal problema el avance lineal, el cual es inferior a lo proyectado por disparo; por ello con la finalidad de aumentar el avance lineal se buscó optimizar factores que incidan en el avance, entre ellos el más importante, el arranque en la malla de perforación. Para ello se realizó la implementación del tipo de malla de perforación con corte cilíndrico determinada mediante la metodología de cálculo propuesta por Holmberg según su esquema de corte y del resto de zonas, para tener datos y poder comparar, se llevó a cabo el seguimiento y control de perforación y voladura de 40 disparos con la malla de perforación con arranque corte quemado, teniendo como longitud promedia de perforación 2.32m y un avance promedio de 1.97m; al implementar el diseño de malla de perforación con corte cilíndrico y en condiciones similares se efectuaron 40 disparos lográndose avanzar 2.13 m en promedio, para una longitud de perforación 2.32m.Y finalmente luego de las pruebas realizadas en campo se logró contrastar con los datos obtenidos y hojas de cálculo la ventaja de la malla de perforación con corte cilíndrico sobre la malla de perforación con corte quemado, el cual es un aumento en 7.1% de avance lineal por disparo, la reducción del factor de potencia de 0.14 Kg/tn por disparo y la disminución en costos por metro lineal de 13.63%