Buscar
Mostrando ítems 1-10 de 606
A passive fault-tolerant control strategy for a non-linear system: An application to the two tank conical non-interacting level control system
(Universidad de las Fuerzas Armadas, 2019)
Fault section location in smart grid using smart switches
(2018-06-25)
This paper proposes the development of a method for monitoring and fault sections location in intelligent distribution systems, which is based on the replacement of equipment traditionally used in the protection of ...
Single-observer based current sensor fault tolerant control for IM traction drives
(Institute of Electrical and Electronics Engineers, 2021-12)
In this work, a current sensors fault tolerant control system (FTCS) for induction motor traction drives is proposed. The FTCS uses a single observer for the detection and isolation of disconnection and gain faults occurred ...
Expert fault detection and diagnosis for the refrigeration process of a hydraulic power plant
(IEEE, 2008)
In this paper we discuss the components and design of each part of an expert system for fault detection and diagnosis in the refrigeration process of a hydraulic power station. Given a minimum group of measurements, it is ...
A structural approach to design sensor networks for fault diagnosis
(American Chemical Society, 2013-12)
Key faults significantly affect the normal operation of the process originating risk conditions. These failures should be identified even in the presence of missing measurements or outliers. In this work a new strategy to ...
Multirotor fault tolerance based on center-of-mass shifting in case of rotor failure
(IEEE RAS, 2021)
This work carries out an analysis on fault tol-erance in multirotor vehicles, particularly for an hexarotorone, where such feature is achieved by shifting the center ofmass in case of a motor failure. It will be shown that, ...
A method for composite fault detection and isolation using overlapping decomposition
(Sociedade Brasileira de Automática, 2003)
Estudo de sensores aplicados na detecção de faltas em geradores síncronos
(Florianópolis, SC, 2021)
Detection and isolation of current-sensor and open-switch faults in electric traction drives
(Institute of Electrical and Electronics Engineers, 2021-08)
In this work, a strategy for detection and isolation of current-sensors and open-switch faults in electric traction drives is proposed. An induction motor drive with only two current sensors is considered for the design ...