Buscar
Mostrando ítems 1-10 de 554
Thixo-forming of Al-Cu alloys
(Elsevier Science SaLausanneSuíça, 1999)
An investigation on semi-solid Al-7Si-0.3Mg alloy produced by mechanical stirring
(Elsevier Science SaLausanneSuíça, 2005)
Analysis of Semi-solid Processing for Metal Matrix Composite Synthesis Using Factorial Design
(Universidade Federal de São Carlos (UFSCar), Dept Engenharia Materials, 2012-01-01)
The main goal in this work is to conduct a quantitative analysis of the mechanical stir casting process for obtaining particulate metal matrix composites. A combined route of stirring at semi-solid state followed by stirring ...
Analysis of Semi-solid Processing for Metal Matrix Composite Synthesis Using Factorial Design
(Universidade Federal de São Carlos (UFSCar), Dept Engenharia Materials, 2012-01-01)
The main goal in this work is to conduct a quantitative analysis of the mechanical stir casting process for obtaining particulate metal matrix composites. A combined route of stirring at semi-solid state followed by stirring ...
Analysis of Semi-solid Processing for Metal Matrix Composite Synthesis Using Factorial Design
(Universidade Federal de São Carlos (UFSCar), Dept Engenharia Materials, 2014)
A comparison of deep drawing and ironing of metal alloy strip produced conventionally and non-conventionally via semi solid material processing
(2008-01-01)
A semi solid thin strip continuous casting process was used to obtain 50%wt Pb/50%wtSn strip by single and twin roll processing at speed of 15 m/min. A 50%wt Pb/50%wtSn plate ingot was also cast for rolling conventionally ...
Evaluation of strip rolling directly from the semi-solid state
(Trans Tech Publications Ltd, 2014)
Effect of macrostructure and microstructure on the viscosity of the A356 alloy in the semi-solid state
(Elsevier Science SaLausanneSuíça, 2004)
Semi-solid behavior of new Al-Si-Mg alloys for thixoforming
(Elsevier Science SaLausanneSuíça, 2005)