Buscar

Mostrando ítems 1-10 de 1420

Microstructure and corrosion resistance of simultaneous nitrided and sintered AiSi 434L powders

TORO, A.; FALLEIROS, N.A.; RODRIGUES, D.; AMBROZIO FILHO, F.; LIBERATI, J.F.; TSCHIPTSCHIN, A.P.; ADVANCED POWDER TECHNOLOGY 2 - INTERNATIONAL LATIN-AMERICAN CONFERENCE ON POWDER TECHNOLOGY, 2nd (Switzerland: Trans Tech Pub., 2001, 2014)

Study of SiC-SiAlON composite formation by nitridation of SiC-Al62.5Si mixture

MAKUNTUALA, K.; BRESSIANI, J.C.; ADVANCED POWDER TECHNOLOGY 2 - INTERNATIONAL LATIN-AMERICAN CONFERENCE ON POWDER TECHNOLOGY, 2nd (Switzerland: Trans Tech Pub., 2001, 2014)

Processing and properties of composites Al/SiC produced by powder metallurgy

MOURISCO, A.J.; AMBROZIO FILHO, F.; ROSSI, J.L.; POWDER METALLURGY WORLD CONGRESS (2014)

Synthesis of SiC-SiAlON composite by nitridation of SiC-AlSi mixture

MAKUNTUALA, K.; BRESSIANI, J.C.; ADVANCED POWDER TECHNOLOGY 2 - INTERNATIONAL LATIN-AMERICAN CONFERENCE ON POWDER TECHNOLOGY, 2nd (Switzerland: Trans Tech Pub., 2001, 2014)

On Ti-18Si-6B and Ti-7.5Si-22.5B powder alloys prepared by high-energy ball milling and sintering

Instituto Tecnológico de Aeronáutica; Instituto Nacional de Pesquisas Espaciais (INPE); Universidade Estadual Paulista (Unesp); Universidade de São Paulo (USP) (ABM, ABC, ABPol, 2012-12-01)

Recently, a new ternary phase was discovered in the Ti-Si-B system, located near the Ti6Si2B composition. The present study concerns the preparation of titanium alloys that contain such phase mixed with α-titanium and other ...

High-Pressure Assisted Sintering of Ti-20Si-10B and Ti-10Si-5B Powders

Univ Fed Alfenas; Universidade Estadual Paulista (Unesp); Univ Vale Paraiba; Univ Estadual Norte Fluminese Darcy Ribeiro (Trans Tech Publications Ltd, 2012-01-01)

This work presents the structural characterization of Ti-10Si-5B and Ti-20Si-10B (at-%) alloys produced by high-pressure assisted sintering. Sintering was performed in air at 1100 and 1200 degrees C for 60 s using pressure ...

Si3N4/SiC nanocomposite powder from a preceramic polymeric network based on poly(methylsilane) as the SiC precursor

Gozzi, Maurício F.; Radovanovic, Eduardo; Yoshida, I. Valéria P. (ABM, ABC, ABPol, 2001)

Structural Evaluation of Mechanically Alloyed (67-x)Ti-xZr-22Si-11B Powders

Universidade Estadual Paulista (Unesp) (Trans Tech Publications Ltd, 2012-01-01)

The present work reports on the structural evaluation of mechanically alloyed Ti-xZr-22Si-11B (x = 5, 7, 10, 15 and 20 at-%) powders. Milled powders and hot-pressed alloys were characterized by X-ray diffraction, electron ...

Development and characterisation of Si-Al-O-N-C ceramic composites from polysiloxane-filler mixtures

ROCHA, R.M.; GREIL, P.; BRESSIANI, J.C.; BRESSIANI, A.H.A.; ADVANCED POWDER TECHNOLOGY 3 - INTERNATIONAL LATIN-AMERICAN CONFERENCE ON POWDER TECHNOLOGY, 2rd (2014)

OBTENTION OF POWDERED CERAMIC MATERIAL BY PYROLYSIS OF POLY [(DIMETHYLSILOXANE)-CO-(DIMETHYLSILAZANE)] COPOLYMERS AS PRECURSORS

RODRÍGUEZ-BAEZA,MARIO; TRUJICHETT BRITO,MARÍA JOSÉ (Sociedad Chilena de Química, 2006)

1
2
3
4
. . .
142