Buscar
Mostrando ítems 1-10 de 2538
Cutting conditions for finish turning process aiming: the use of dry cutting
(Pergamon-elsevier Science LtdOxfordInglaterra, 2002)
The integrated lot sizing and cutting stock problem in a furniture factory
(2013-08-08)
This work studies the integrated lot sizing and cutting stock problem, where the goal is to capture the dependency that exists between two important decisions in the production process, in order to economize raw materials ...
The integrated lot sizing and cutting stock problem in a furniture factory
(2013-08-08)
This work studies the integrated lot sizing and cutting stock problem, where the goal is to capture the dependency that exists between two important decisions in the production process, in order to economize raw materials ...
Optimizing cutting parameters for cutting power and roughness in VAT 32® turning with an experimental Al2O3method
(2018-01-01)
The development of new materials for manufacturing of combustions engines grows as environmental regulations increase. New technologies related to combustion have been developed, causing higher working temperatures inside ...
Optimizing the use of dry cutting in rough turning steel operations
(Elsevier Sci LtdOxfordInglaterra, 2004)
Using Simulated Annealing with a Neighborhood Heuristic for Roll Cutting Optimization
(Revista Computación y Sistemas; Vol. 13 No.1, 2009-08-15)
Abstract This article presents the use of the Simulated Annealing algorithm with a heuristic to solve the waste minimization problem in roll cutting programming, in this case, paper. Client orders, which vary in weight, ...
Global analysis of aerodynamics deflectors efficiency in the grinding process
(2006-07-17)
The conventional, grinding methods in some cases are not very efficient because the arising of thermal damages in the pieces is very common. Optimization methods of cutting fluid application in the grinding zone are essential ...
Global analysis of aerodynamics deflectors efficiency in the grinding process
(2006-07-17)
The conventional, grinding methods in some cases are not very efficient because the arising of thermal damages in the pieces is very common. Optimization methods of cutting fluid application in the grinding zone are essential ...