Buscar
Mostrando ítems 1-10 de 9182
Bending of stainless steel thin sheets by a raster scanned low power CO2 laser
(ELSEVIER SCIENCE SA, 2009)
Laser forming of thin metal sheet plates using a low output power CO2 laser has been successfully performed using a mirror based scanning system. Graphite coated AISI 302 stainless steel plates, 0.3 mm thick, have been ...
Reducing scanning keyboard input errors with extended start dwell-time
(2019-01-01)
Some individuals with reduced motor function rely on scanning keyboards to operate computers. A problem observed with scanning keyboards is that errors typically occur during the first group or first cell of a group. This ...
Sistemas biodegradáveis contendo acetato de prednisolona para administração orbitária
(2009-07-01)
Purpose: The present study aimed to evaluate an injectable extended-release formulation of prednisolone acetate (PA) for orbital administration. Methods: Microspheres (MEs) of poly-ε-caprolactone (PCL) containing PA were ...
Sistemas biodegradáveis contendo acetato de prednisolona para administração orbitária
(2009-07-01)
Purpose: The present study aimed to evaluate an injectable extended-release formulation of prednisolone acetate (PA) for orbital administration. Methods: Microspheres (MEs) of poly-ε-caprolactone (PCL) containing PA were ...
Assisted prescribing: clinical decision support with medsafety scan now available
Too often, adverse events due to prescription medications are a cause of death and
disability. Many of these events could be prevented, but most efforts to do so have had limited
success, mainly due to the challenges of ...
Indirect georeferencing of terrestrial laser scanning data using control lines
(2013-09-01)
An indirect method for the georeferencing of 3D point clouds obtained with terrestrial laser scanning (TLS) data using control lines is presented. This technique could be used for rapid data acquisition where resources do ...
Indirect georeferencing of terrestrial laser scanning data using control lines
(2013-09-01)
An indirect method for the georeferencing of 3D point clouds obtained with terrestrial laser scanning (TLS) data using control lines is presented. This technique could be used for rapid data acquisition where resources do ...
Scanning electron microscopy comparison of the resin–dentin interface using different specimen preparation methods
(2020-08-01)
Microscopy has been widely used to complement the data of studies related to dentin bonding; however, different specimen preparation methods may influence the analysis. Aiming to contribute to the reported scenario, this ...