Buscar
Mostrando ítems 1-10 de 308
A passive fault-tolerant control strategy for a non-linear system: An application to the two tank conical non-interacting level control system
(Universidad de las Fuerzas Armadas, 2019)
Fault Tolerant MPC Controller for Electric Heater Control
(Universidad UTE, 2018)
Single-observer based current sensor fault tolerant control for IM traction drives
(Institute of Electrical and Electronics Engineers, 2021-12)
In this work, a current sensors fault tolerant control system (FTCS) for induction motor traction drives is proposed. The FTCS uses a single observer for the detection and isolation of disconnection and gain faults occurred ...
Multirotor fault tolerance based on center-of-mass shifting in case of rotor failure
(IEEE RAS, 2021)
This work carries out an analysis on fault tol-erance in multirotor vehicles, particularly for an hexarotorone, where such feature is achieved by shifting the center ofmass in case of a motor failure. It will be shown that, ...
Behavioural Preservation in Fault Tolerant Patterns
(Universidade Federal de Pernambuco, 2015)
Reconfiguration blocks for fault-tolerant control of nonlinear systems
(Universidade Federal de Minas GeraisBrasilENG - DEPARTAMENTO DE ENGENHARIA ELETRÔNICAPrograma de Pós-Graduação em Engenharia ElétricaUFMG, 2022-06-01)
Industrial processes and technological systems are becoming more and more autonomous and complex. Consequently, the demand for the safety and reliability of these systems is increasing. In this context, process monitoring ...
Leg-Shared Fault Tolerant Predictive Control of PMSM Drive Systems Fed by Three-Level Back-To-Back Converters
(Institute of Electrical and Electronics Engineers Inc., 2021)
Reliability is one of the most important characteristics of motor drive system, especially after power semiconductor device open-circuit fault occurs. Effective fault tolerant control methods are considered crucial to ...
Fault Tolerant Reconfiguration System for Asymmetric Multilevel Converters Using Bi-Directional Power Switches
(IEEE, 2007)
Asymmetric multilevel converters can optimise the number of levels by using H bridges scaled in power of three. The shortcoming of this topology is that the H bridges are not interchangeable and then, under certain faulty ...