Buscar
Mostrando ítems 1-10 de 55
Analysis and design of constant-frequency peak-current-controlled high-power-factor boost rectifier with slope compensation
(1996-01-01)
This paper presents the analysis and the design of a peak-current-controlled high-power-factor boost rectifier, with slope compensation, operating at constant frequency. The input current shaping is achieved, with continuous ...
Interleaved Boundary Conduction Mode Versus Continous Conduction Mode Magnetic Volume Comparison in Power Converters
(Institute of Electrical and Electronics Engineers, 2016-12)
Power converters operating in boundary conduction mode (BCM) can benefit from an efficiency increase compared to continuous conduction mode (CCM) based on the soft-switching transitions at turn-on and/or turn-off. However, ...
Sliding-mode indirect control of the quadratic boost converter operating in continuous conduction mode or discontinuous conduction mode
(2012 IEEE 4th Colombian Workshop on Circuits and Systems (CWCAS), 2020)
Analysis and design of constant-frequency peak-current-controlled high-power-factor boost rectifier with slope compensation
(1996-01-01)
This paper presents the analysis and the design of a peak-current-controlled high-power-factor boost rectifier, with slope compensation, operating at constant frequency. The input current shaping is achieved, with continuous ...
Modeling of pre-regulator boost ZCS interleaved operating in critical conduction mode and with high power factor
(2002-12-01)
This paper presents a new pre-regulator boost operating in the boundary area between the continuous and discontinuous conduction modes of the boost inductor current, where the switches and boost diode performing zero-current ...
Modeling of pre-regulator boost ZCS interleaved operating in critical conduction mode and with high power factor
(2002-12-01)
This paper presents a new pre-regulator boost operating in the boundary area between the continuous and discontinuous conduction modes of the boost inductor current, where the switches and boost diode performing zero-current ...
A DC-DC converter based on the three-state switching cell for high current and voltage step-down applications
(2013-01-01)
This paper presents a pulsewidth modulation dc-dc nonisolated buck converter using the three-state switching cell, constituted by two active switches, two diodes, and two coupled inductors. Only part of the load power is ...
A DC-DC converter based on the three-state switching cell for high current and voltage step-down applications
(2013-01-01)
This paper presents a pulsewidth modulation dc-dc nonisolated buck converter using the three-state switching cell, constituted by two active switches, two diodes, and two coupled inductors. Only part of the load power is ...