Buscar
Mostrando ítems 1-10 de 1265
Improvement of coating adhesion on cemented carbide tools by plasma etching
(Universidade Federal do Rio de Janeiro - UFRJ, 2016-05-04)
Improvement of coating adhesion on cemented carbide tools by plasma etching
(Springer, 2016-05-04)
Turning of compacted graphite iron using commercial tiN coated Si 3N4 under dry machining conditions
(2008-12-01)
Due to their high hardness and wear resistance Si3N4 based ceramics are one of the most suitable cutting tool materials for machining hardened materials. Therefore, their high degree of brittleness usually leads to ...
Turning of compacted graphite iron using commercial tiN coated Si 3N4 under dry machining conditions
(2008-12-01)
Due to their high hardness and wear resistance Si3N4 based ceramics are one of the most suitable cutting tool materials for machining hardened materials. Therefore, their high degree of brittleness usually leads to ...
Microstructural analyses and wear behavior of the cemented carbide tools after laser surface treatment and PVD coating
(Elsevier Science BvAmsterdamHolanda, 2013)
Performance of carbide tools coated with DLC in the drilling of SAE 323 aluminum alloy
(Elsevier B.V., 2015-12-25)
The development of new coatings in the last years contributed to the improvements of machining industry. In general, it is known that the performance of drilling tools increases with the application of a proper coating, ...
Cutting performance of diamond coated Si3N4 tool during turning
(2010-12-15)
Silicon nitride cutting tools have been used successfully for machining hard materials, like: cast irons, nickel based alloys, etc. However these cutting tools with diamond coating present little information on dry turning ...
Cutting performance of diamond coated Si3N4 tool during turning
(2010-12-15)
Silicon nitride cutting tools have been used successfully for machining hard materials, like: cast irons, nickel based alloys, etc. However these cutting tools with diamond coating present little information on dry turning ...