Buscar
Mostrando ítems 1-10 de 789
Development of ceramic cutting tools for future application on dry machining
(2010-12-15)
Advanced ceramic materials constitute a mature technology with a very broad base of current and potential applications and a growing list of material compositions. Within the advanced ceramics category, silicon nitride ...
Development of ceramic cutting tools for future application on dry machining
(2010-12-15)
Advanced ceramic materials constitute a mature technology with a very broad base of current and potential applications and a growing list of material compositions. Within the advanced ceramics category, silicon nitride ...
Neural tool condition estimation in the grinding of advanced ceramics
(2015-01-01)
Ceramic parts are increasingly replacing metal parts due to their excellent physical, chemical and mechanical properties, however they also make them difficult to manufacture by traditional machining methods. The developments ...
Hard turning in continuous and interrupted cut with PCBN and whisker-reinforced cutting tools
(Elsevier Science SaLausanneSuíça, 2009)
Effect of green machining on distortion and surface finishing in advanced ceramic
(2012-11-28)
An alternative for grinding of sintered ceramic is the machining on the green state of the ceramic, which presents easy cutting without the introduction of harmful defects to its mechanical resistance. However, after ...
Turning of interrupted and continuous hardened steel surfaces using ceramic and CBN cutting tools
(Elsevier Science SaLausanneSuíça, 2011)
α-SiAION: Development and machining test on gray cast iron
(2008-12-01)
The α-SiAlON ceramic cutting tool insert is developed. Silicon nitride and additives powders are pressed and sintered in the form of cutting tool inserts at temperature of 1900 °C. The physics and mechanical properties of ...
α-SiAION: Development and machining test on gray cast iron
(2008-12-01)
The α-SiAlON ceramic cutting tool insert is developed. Silicon nitride and additives powders are pressed and sintered in the form of cutting tool inserts at temperature of 1900 °C. The physics and mechanical properties of ...