Buscar
Mostrando ítems 41-50 de 4656
Study of heat transfer in tubular-panel and spray cooling systems applied to the electric arc furnace walls
(Instituto Tecnológico y de Estudios Superiores de Monterrey, 2018-05-15)
This project consists in a heat transfer study in the electric arc furnace (EAF) walls, focused in the tubular-panel and spray cooling systems for the EAF located at Ternium-Guerrero plant, in the northeastern region of ...
Analysis of the influence of baffles and shields on the cooling of a digital transmission equipment
(Institute of Electrical and Electronics Engineers (IEEE), 1996-01-01)
In this work design criteria for cooling of electronic systems used in a digital transmission equipment are considered. An experimental study using a simulated electronic equipment in which vertically oriented circuit ...
Indirect cooling of the cutting tool with a pumped two-phase system in turning of AISI 1045 steel
(2016-12-01)
The elimination of cutting fluids’ usage is one of the great challenges of sustainable manufacturing. Various devices and alternative techniques have been developed, but their results are limited, as well as their commercial ...
The cooling-rate effect on microwave archeointensity estimates
(Washington, 2013)
New microwave (MW) paleointensity data on historical bricks from Northeast Brazil presented a bias toward higher fields when compared to previous cooling-rate corrected double-heating paleointensity estimates; the same ...
Commissioning of a cooling ceiling system in HVAC applicationsAuditoria energética de un sistema de enfriamiento tipo techo en aplicaciones HVAC/R
(Pereira : Universidad Tecnológica de PereiraFacultad de Ciencias Básicas, 2011)
A sustainable alternative for cooling the machining processes using a refrigerant fluid in recirculation inside the toolholder
(Springer, 2011-12-01)
This article presents a cooling system for cutting tool in turning based in a toolholder with cooling fluid flowing inside its body being that this fluid must necessarily be able to phase change due to heat generated from ...
A sustainable alternative for cooling the machining processes using a refrigerant fluid in recirculation inside the toolholder
(Springer, 2011-12-01)
This article presents a cooling system for cutting tool in turning based in a toolholder with cooling fluid flowing inside its body being that this fluid must necessarily be able to phase change due to heat generated from ...
A data acquisition system for water heating and cooling experiments
(2017-01-01)
This work presents a simple analogue waterproof temperature probe design and its electronic interfacing with a computer to compose a data acquisition system for water temperature measurement. It also demonstrates the system ...
Power losses analysis and cooling system design of three topologies of multilevel inverters
(2008-09-29)
This paper presents the comparison of three topologies of multilevel inverters applied to drive an induction motor of 500 kVA/4.16 kV. The multilevel inverters analyzed are: a neutral point clamped inverter, a symmetrical ...
Power losses analysis and cooling system design of three topologies of multilevel inverters
(2008-09-29)
This paper presents the comparison of three topologies of multilevel inverters applied to drive an induction motor of 500 kVA/4.16 kV. The multilevel inverters analyzed are: a neutral point clamped inverter, a symmetrical ...