Buscar
Mostrando ítems 11-20 de 100
Evaluation of strip rolling directly from the semi-solid state
(2006-01-01)
The aim of this work is to study the solidification conditions necessary to produce good quality/low defect metal alloy strip when thixorolling directly from the semi-solid state. To facilitate the study lead/tin alloys ...
Influence of pouring temperature and alloy additions on the quality of a semisolid material dragged during the continuous-casting strip processing of al-si a413
(2019-01-01)
Al–Si A413 treated and untreated alloys were cast and poured at approximately 720 ºC, 700 ºC, and 680 ºC in a cooling slope to obtain the semisolid material feeding the ceramic nozzle (150 cm 3 ) at the lower roll (single-roll ...
Continuous production of a multi-filament reinforced metal matrix composite strip from the semisolid state
(2014-01-01)
Continuous metal matrix composite strip casting (MMCS-ing) composed of six 0.3-mm diameter annealed bare copper wires in a eutectic SnPb matrix was manufactured by a two-roll melt dragged processing (TRMD-ing) method at a ...
A Comparison of Deep Drawing and Ironing of Metal Alloy Strip Produced conventionally and Non-conventionally via Semi Solid Material Processing
(Trans Tech Publications Ltd, 2014)
Martensitic transformation strain and stability of Ni50-x-Ti50-Cox (x=3,4) strips obtained by twin-roll casting and standard processing techniques
(Elsevier Ltd, 2016-10)
The martensitic transformation properties (maximum strain, residual strain and transformation stability) of Ni50-x-Ti50-Cox strips produced by twin-roll casting (TRC) and standard casting (SC) were compared. A complete ...
Modelling of twin-roll strip casting processes
(WILEY, 2003)
Manufacture of continuous metal matrix composite strip reinforced by particulate materials from the semisolid processing
(2019-01-01)
Strip casting is a new method of producing metal matrix composites. Two-roll melt dragged processing (TRMD-ing) and single-roll melt dragged processing (SRMD-ing) methods were used to study the manufacture of 2-mm-thick ...
Load-biased martensitic transformation strain of Ti50-Ni47-Co3 strip obtained by a twin-roll casting technique
(Elsevier, 2014-01)
Mechanical properties of the Ti50?Ni47?Co3 (at%) strips produced by twin-roll casting are analyzed, focusing on the maxim umrecoverable strain obtained by inducing the martensitic transformation under constant tensile load. ...
Recycling Al-Si Alloy by Semisolid Material Dragged During Continuous-Casting Strip Processing
(2022-01-01)
Recycled Al–Si (9.2%) alloy contaminated with Fe (0.3%), Pb (3.1%) and Sn (11.4 %) was cast and poured at 650 ºC, approximately 50 ºC above the liquidus line. A cooling slope was used to obtain a semisolid material that ...