Buscar
Mostrando ítems 11-20 de 199
Effect of Equal Channel Angular Pressing (ECAP) on microstructure and properties of Al-FeAlCr intermetallic phase composites
(ABM, ABC, ABPol, 2014-06-01)
An aluminium matrix composite was prepared by mixing commercial aluminium powders and 15 vol % of FeAlCr powders and consolidation by hot extrusion. The extruded composite was subjected to severe plastic deformation by ...
Exchange-bias-like effect in Pr0.75Tb0.25Al2 and Pr0.7Tb0.3Al2 samples
(Elsevier Science BvAmsterdamHolanda, 2013)
Abrasion and corrosion resistance of new Ni-based coating deposited by HVOF thermal spray process
(MANEY PUBLISHING, 2010)
Coatings based on NiCrAlC intermetallic based alloy were applied on AISI 316L stainless steel substrates using a high velocity oxygen fuel torch. The influence of the spray parameters on friction and abrasive wear resistance ...
Influence of Pt-Sn System Nanostructure on the Electronic Conditions at a Pt Adsorption Surface Site
(Amer Chemical Soc, 2018-05-31)
This paper describes the synthesis and full characterization of Pt-Sn intermetallics with the same stoichiometry and similar particle size but distinct atomic arrangements (ordered intermetallic, ordinary alloy, and ...
Microstructure and mechanical behavior of in situ Ni-Ni3Si composite
(Elsevier Science SaLausanneSuíça, 2007)
Dendritic Spacing and Macrosegregation Affecting Microhardness of an Al-Si-Mg Alloy Solidified Under Unsteady State Conditions
(Univ Fed Sao Carlos, Dept Engenharia Materials, 2019-01-01)
The prediction of microstructure morphology is fundamental for the manufacture of metallic components, since the expected levels of mechanical properties will be associated with the final aspects of the microstructure. In ...