Actas de congresos
Experimental Modal Analysis Of A Cavity Using A Calibrated Acoustic Actuator
Registro en:
9073802725; 9789073802728
Proceedings Of The 25th International Conference On Noise And Vibration Engineering, Isma. , v. , n. , p. 1437 - 1444, 2000.
2-s2.0-13444251427
Autor
Rossetto G.D.
Arruda J.R.F.
Huallpa B.N.
Institución
Resumen
In this paper, the acoustical modal analysis of a rectangular shallow cavity is performed. It is shown that a suitable choice for the acoustical excitation is the volume acceleration and, for the acoustical response, the sound pressure. When using a Finite Element model and an analytical model, it is shown that the computed Frequency Response Functions must be multiplied by the mass density of the air to yield units of Pascal per unit volume acceleration (m3/s2), which are straightforward to obtain experimentally. In the experiments, two types of excitation devices were used. The first utilizes a shaker-driven piston which thrusts against a thin rubber membrane stretched flush to one of the cavity side walls, covering a cylindrical hole. The other actuator was built based upon a research report developed in an EEC project (Brite-EuRam II: PIANO). This acoustic actuator has a high impedance (higher than any practical surrounding impedance) so that the impedance of the cavity does not need to be considered in the calibration factor relating the microphone signal and the source strength. A good agreement was obtained in the comparisons between experimental, analytical and numerical Frequency Response Functions and modes.
1437 1444 Kinsler, L.E., Frey, A.R., Coppens, A.B., Sanders, J.V., (1982) Fundamentals of Acoustics, Third Edition, , John Wiley & sons Van Tol, F.H., Verheij, J.W., (1993) Loudspeaker for Reciprocal Measurements of Near Field Sound Transfer Functions on Heavy Road Vehicle Engines, , TNO Institute of Applied Physics Kwon, Y.W., Bang, H., (1997) The Finite Element Method Using Matlab, , CRC Press Ewins, D.J., (1984) Modal Testing and Practice, , RSP/John Wiley & sons Augusztinovicz, F., Sas, P., Acoustic modal analysis at low frequencies: Similarities and differences in formulations (1996) Proc. 21st Int. Seminar on Modal Analysis, 3, pp. 1650-1699. , Ed.: P. Sas Nieter, J.J., Singh, R., Acoustic modal analysis experiment (1982) J. Acoustic Soc. Am., 72 (2). , August Kung, C., Singh, R., Acoustic modal analysis technique for three-dimensional acoustic cavities (1985) J. Acoustic Soc. Am., 77 (2). , February Whear, F.R., Morrey, D., A technique for experimental acoustic modal analysis (1996) Proc. Instn. Mech. Engrs, 210 Byrne, K., The use of acoustic pressure measurement to determine the particle motions associated with the low order acoustic modes in enclosures (1985) J. Acoustic Soc. Am., 77 (2). , February Arruda, J.R.F., Surface smoothing and partial derivatives computation using a regressive discrete Fourier series (1992) Systems and Signal Processing, 6 (1), pp. 41-50