Artículos de revistas
Effect of different methods of cutting fluid application on turning of a difficult-to-machine steel (SAE EV-8)
Date
2013-02-01Registration in:
Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, v. 227, n. 2, p. 220-234, 2013.
0954-4054
2041-2975
10.1177/0954405412467589
WOS:000317990600003
2-s2.0-84875896213
Author
Universidade Estadual Paulista (UNESP)
University of Toledo
Institutions
Abstract
In this study, different methods of cutting fluid application are used in turning of a difficult-to-machine steel (SAE EV-8). Initially, a semisynthetic cutting fluid was applied using a conventional method (i.e. overhead flood cooling), minimum quantity of cutting fluid, and pulverization. A lubricant of vegetable oil (minimum quantity of lubricant) was also applied using the minimum quantity method. Thereafter, a cutting fluid jet under high pressure (3.0 MPa) was singly applied in the following regions: chip-tool interface, top surface of the chip (between workpiece and chip) and tool-workpiece contact. Moreover, two other methods were used: an interflow between conventional application and chip-tool interface jet (combined method) and, finally, three jets simultaneously applied. In order to carry out these tests, it was necessary to set up a high-pressure system using a piston pump for generating a cutting fluid jet, a venturi for fluid application (minimum quantity of cutting fluid and minimum quantity of lubricant) and a nozzle for cutting fluid pulverization. The output variables analyzed included tool life, surface roughness, cutting tool temperature, cutting force, chip form, chip compression rate and machined specimen microstructure. Among the results, it can be observed that the tool life increases and the cutting force decreases with the application of cutting fluid jet, mainly when it is directed to the chip-tool interface. Excluding the methods involving jet fluid, the conventional method seems to be more efficient than other methods of low pressure, such as minimum quantity of volume and pulverization, when considering just the cutting tool wear. © 2013 IMechE.
Subjects
Related items
Showing items related by title, author, creator and subject.
-
Different methods of cutting fluid application on turning of a difficult-to-machine steel
Sanchez, L. E A; Palma, G. L.; Nalon, L. J.; Santos, A. E.; Modolo, D. L. -
Different methods of cutting fluid application on turning of a difficult-to-machine steel
Universidade Estadual Paulista (UNESP) (2013-02-01)Different methods of cutting fluid application are used on turning of a difficult-tomachine steel (SAE EV-8). A semi-synthetic cutting fluid was applied using a conventional method, minimum quantity of cutting fluid (MQCF), ... -
Studies on the Effects of Fixatives on the Staining Ability of Morinda lucida Extracts on Tissue Sections
Avwioro,O. G.; Imosemi,I. O.; Oduola,T.; Adisa,O. J.; Oladele,A. A.