Buscar
Mostrando ítems 1-10 de 165
Wind loads on buildings with vaulted roofs and side walls: a review
(Elsevier Science, 2017-02)
The recommendations of the Argentinean code of practice CIRSOC 102 concerning wind loads on enclosed buildings with curved roofs are identical to those of ASCE 7, which are based on results published in 1914. Significant ...
Load cells calibration with a low cost data acquisition system
(Universidade Tecnológica Federal do Paraná (UTFPR), 2019)
Functional Autoregressive Models: An Application to Brazilian Hourly Electricity Load
(Sociedade Brasileira de Econometria, 2017)
Experimental determination of J-resistance curves of nuclear steam generator tubes
(Pergamon-Elsevier Science Ltd, 2016-09-08)
The experimental determination of room temperature J-resistance curves of thin walled Incoloy 800 nuclear steam generator tubes was studied. Different non-standard specimens’ geometries were considered, including circumferential ...
Inverse method for the analysis of instrumented impact tests of polymers
(Elsevier, 2007-09-02)
Impact testing has become an important technique to determine the parameters associated with dynamic fracture of polymeric materials. These parameters are commonly calculated from the experimentally measured load versus ...
Analysis of the Spb method for geometries where ηpl depends on a/W
(Elsevier, 2021-01)
Since its proposal, the simplified Spb method has been successfully applied to the fracture toughness evaluation of metallic and polymer materials. However, some points of this methodology remain unclear, like the applicability ...
In-plane and out-of-plane dynamics and buckling of functionally graded circular curved beams
(Elsevier, 2012-11)
In this paper the dynamic and buckling features of slender structures with curved axis are addressed. A survey on the literature concerning mechanics of beams constructed with non-homogeneous materials or with functionally ...
Magnetic behavior of iron-modified MCM-41 correlated with clustering processes from the wet impregnation method
(Elsevier Science, 2016-03)
Magnetic MCM-41 type mesoporous silica materials were synthetized and modified with different iron loadings by the wet impregnation method. The evolution of iron speciation, depending on the metal loading and associated ...
Calibration of high-temperature furnace assemblies for experiments between 200 and 600 MPa with end‑loaded piston-cylinder apparatuses
(Sociedade Brasileira de Geologia, 2019)
Circular Switching Surface Technique: High-Performance Constant Power Load Stabilization for Electric Vehicle Systems
(Institute of Electrical and Electronics Engineers, 2015-08)
Electric vehicles make use of energy storage systems, such as batteries and/or ultracapacitors to power the electric power drive train, as well as auxiliary automotive system for control, safety, and comfort. This relatively ...