Buscar
Mostrando ítems 1-10 de 95
Investigation on Surface Finishing of Components Ground with Lapping Kinematics: Lapgrinding Process
(Trans Tech Publications Ltd, 2011-01-01)
Over the last three decades, researchers have responded to the demands of industry to manufacture mechanical components with geometrical tolerance, dimensional tolerance, and surface finishing in nanometer levels. The new ...
Neural network approach for surface roughness prediction in surface grinding
(2007-12-01)
Several systems are currently tested in order to obtain a feasible and safe method for automation and control of grinding process. This work aims to predict the surface roughness of the parts of SAE 1020 steel ground in a ...
Effect of green machining on distortion and surface finishing in advanced ceramic
(2012-11-28)
An alternative for grinding of sintered ceramic is the machining on the green state of the ceramic, which presents easy cutting without the introduction of harmful defects to its mechanical resistance. However, after ...
Effect of green machining on distortion and surface finishing in advanced ceramic
(2012-12-01)
An alternative for grinding of sintered ceramic is the machining on the green state of the ceramic, which presents easy cutting without the introduction of harmful defects to its mechanical resistance. However, after ...
Study of the phenomena of fatigue using the finite element method
(2007-12-01)
About 99% of mechanical failures are consequence of the phenomena of fatigue, which consists on the progressive weakening of the resistant section of a mechanical component due to the growing of cracks caused by fluctuating ...
Effect of Hot Burnishing Aided by Infrared Radiation on the Modification of Surface and Subsurface of AISI 1045 Steel
(2017-01-01)
The burnishing occurs by plastic deformation by rearranging the excess of material on the surface peaks to its valleys. In order to improve the process, a laser can be used as a heating source to reduce the material yield ...