Dissertação
Caracterização química do esmalte dental humano após infiltração de resina através do fluxo eletrocinético
Autor
Martins, Lídia Batista Conrado
Institución
Resumen
The traditional technique for diffusion of molecules through dental enamel has
limitations due to the small size of the pores present in the tissue. In an attempt to
optimize the transport of molecules into these pores, the application of electrokinetic
flow (ECF) seems to be a promising alternative. Based on a process that generates an
electrical potential difference, its application causes movement of the molecules
through the enamel nanopores. The objective of this "in vitro" study was to determine
the chemical alterations of dental enamel by Fourier Transform Infrared Spectroscopy
in the attenuated total reflection mode (FTIR-ATR) after infiltration of an infiltrating resin
(Icon Caries Infiltrant Proximal) by FEC. Five third molars were used, which were
sectioned longitudinally in the mesio-distal direction, resulting in two hemicrowns. The
bands for phosphate, carbonate, protein amide I, C=O bond and for the CH bond were
analyzed. (2800-3015 cm−1
). It was not observed change in the phosphate, amide, and
carbonate bands between the infiltrated and non-infiltrated samples. It was also
verified the presence of a low intensity band referring to the C=O bond, not seen
previously, and an increase in the intensity of the area of the C-H bond in the infiltrated
enamel spectrum. The resin was infiltrated into the dental enamel via FEC. However,
the vibrational bands presented lower levels than expected, probably due to the small
volume of the nanopores in the tissue constitution. The FTIR-ATR method does not
seem to have the necessary sensitivity to determine the resin infiltrated into the enamel
by FEC. A aplicação do fluxo eletrocinético (FEC) se apresenta como uma alternativa
promissora no intuito de se otimizar o transporte de moléculas para o interior
dos poros do esmalte, dispensando-se o uso da técnica adesiva convencional.
Esse processo é baseado na geração de diferença de potencial elétrico, sendo
que sua aplicação possibilita a movimentação de moléculas através dos
nanoporos do esmalte. O objetivo deste estudo in vitro foi avaliar as alterações
químicas do esmalte dentário por meio de análise por Espectroscopia no
Infravermelho por transformada de Fourier no modo de reflexão total atenuada
(FTIR-ATR) após infiltração de resina fluida tipo infiltrante (Icon Caries Infiltrant
Proximal) utilizando-se o FEC. Cinco terceiros molares foram utilizados, os
quais foram seccionados longitudinalmente no sentido mesio-distal, resultando
em duas hemicoroas. Foram analisadas as bandas para fosfato (, carbonato,
proteína amida I, ligação C=O e ligação C-H. Não se observou alteração das
bandas de fosfato, amida, e carbonato entre os espécimes infiltrados e nãoinfiltrados. Verificou-se, também, a presença de banda de baixa intensidade
referente à ligação C=O, anteriormente inexistente, e aumento de intensidade
da área da ligação C-H no espectro do esmalte infiltrado. A resina foi infiltrada
no esmalte dental via FEC, entretanto, os sinais das bandas vibracionais foram
verificados em níveis mais baixos, provavelmente devido ao pequeno volume
dos nanoporos na constituição do tecido. O método de FTIR-ATR parece não
ter a sensibilidade necessária para se determinar a presença da resina infiltrada
no esmalte. FAPEMIG - Fundação de Amparo à Pesquisa do Estado de Minas Gerais