With the popularization of 3D printing technologies, it is now possible to develop patient specific simulators and various other accessories using this technology in medical physics and dosimetry. This work aims to evaluate the electronic equilibrium of 3D printed phantoms using PLA and ABS filaments compared to PMMA for 137Cs gamma rays using OSL dosimetry. A Landauer microStar ii commercial OSL system were commissioned and it was used nanoDot dosimeters. Phantom plates with 2.5, 3.0 and 5.0 mm thickness were used to obtain electronic equilibrium for 137Cs gamma rays. Measurements were compared with PMMA measurements at standard conditions. Results show that measurements with ABS and PLA thicknesses of 2.5 and 3.0 mm presents dosimetry results within irradiation uncertainty. More accuracy is obtained using 3.0 mm for both PLA and ABS phantoms, with differences in less than 0.5%. It can be concluded that PLA and ABS 3D phantom plates has similar properties of PMMA for 137Cs gamma rays dosimetry and can be used for developing dosimetry accessories for this energy photon beam.Funda????o de Amparo ?? Pesquisa do Estado de S??o Paulo (FAPESP)Conselho Nacional de Desenvolvimento Cient??fico e Tecnol??gico (CNPq)Coordena????o de Aperfei??oamento de Pessoal de N??vel Superior (CAPES)FAPESP: 17/50332-0CNPq: 142098/2017-5CAPES: 554/2018