Nowadays the electrical energy was been used much on society. A method for getting electricity is through nuclear power plants, this power plant uses fission that occurs inside the UO2 pellets to generate thermal energy that will be transform into electric. The pellets production was made from enriched UF6 uses some techniques of reprocessing UF6 gas to UO2 powder. This reprocessing process done by wet route (Ammonium Diuranate ADU or Ammonium Uranium Carbonate AUC) or by dry route (Fluidized bed or GECO). With getting of UO2 powder is forwarded to metallurgy where this powder is compacted in cylindrical matrix so that powder take the desired shape, this green pellets are full of the empty spaces (porosity) for this it is sent to the sintering. The sintering consists of a joint of these particles of powders by means of the heating of this green pellets, coming arrive the melting temperature, the UO2 molecules melting each other so decrease the porosity and increase the density. For the production of fuel pellets the process all most used is wed route by means the AUC ,this process arrive created for replace the ADU because the AUC is a process where less rework for the pore geometry is required compared to DUA. The fluidized bed process is more used in small samples however, for a large amount it becomes unfeasible, moreover the dry route process require more robust materials because of the generation of HF that is highly corrosive and cannot used the UNH (uranyl nitrate hexahydrate) used for recycle materials discarded in manufacturing.