info:eu-repo/semantics/article
Verticalization of molars with double cantilever system: finite element analysis.
Verticalización de molares con sistema de cantilever doble: análisis de elementos finitos.
Autor
Marquez Reyes, Giuliana
Oliveira, Cristina
Institución
Resumen
Molar uprighting has been classified as a clinical challenge since it is a treatment that presents extreme complexity and several undesirable effects. One of these effects is the extrusion of the molar because most of the systems used do not have a correct vertical control. The objective of this study is to determine the forces and effects that cause the application of double cantilever in the molar uprighting since this system has been used clinically in the past to straighten without causing extrusion. This objective will be fulfilled through a study of finite elements that consists in the creation of virtual structures that act exactly like the real object. After performing several simulations, it was verified that the double cantilever has not only the ability to avoid molar extrusion but also to cause an average of 1.29mm of molar intrusion. Also, it was verified that there are large areas of compression and tension in several zones of the molar and the tube. La verticalización de molares ha sido catalogada como un reto clínico para el ortodoncista, ya que es un tratamiento que presenta una extrema complejidad y varios efectos indeseables. Uno de dichos efectos es la extrusión del molar al enderezarlo pues con la mayoría de los sistemas empleados no se tiene un correcto control vertical. El objetivo de este estudio fue determinar el sistema de fuerzas y efectos que provoca la aplicación del cantilever doble en la verticalización de un molar ya que este sistema ha sido utilizado clínicamente con el fin de verticalizar sin provocar extrusión. Dicho objetivo se cumplió mediante un estudio de elementos finitos que consiste en la creación de estructuras virtuales que semejan exactamente las mismas características de un objeto real. Después de la realización de varias simulaciones se verificó que el cantilever doble no solamente tiene la capacidad de evitar la extrusión del molar sino también la de provocar un promedio de 1.29mm de intrusión de la pieza. Asimismo, se verificó que existe grandes áreas de compresión y tensión en varias zonas del molar y del tubo.