Configuración de un post-procesador del software Sprutcam para la generación de código nc del control Mitsubishi meldas 60s del torno tipo suizo Polygim20csb
Fecha
2019-01-29Registro en:
Guevara Pedraza, A. C. (2019). Configuración de un post-procesador del software Sprutcam para la generación de código nc del control Mitsubishi meldas 60s del torno tipo suizo Polygim20csb. Universidad Santo Tomás. Bogotá, Colombia
reponame:Repositorio Institucional Universidad Santo Tomás
instname:Universidad Santo Tomás
Autor
Guevara Pedraza, Andrés Camilo
Institución
Resumen
The problem presented by the Swiss lathe Polygim20CSB owned by the Universidad Santo Tomás and that the technological capacity of the students and professors of the Faculty of Mechanical Engineering had not been exploited, due to this the implementation was analyzed, analyzed and developed. of a post-processor in the SprutCAM Software for the Mitsubishi Meldas60S control which generates NC code for the Swiss type lathe Polygim20CSB. At the same time, through a plan of virtual and face-to-face tests in the laboratories of the university, a piece was produced that contains the basic operations of turning and phrasing to check the functioning of the post-processor and thereby provide future students with the possibility of carrying out new practices with a tool that was not in use.