Artículos de revistas
An esthetics rehabilitation with computer-aided design/ computer-aided manufacturing technology
Fecha
2014Registro en:
The journal of contemporary dental practice, v. 15, n. 4, p. 506-512, 2014.
1526-3711
10.5005/jp-journals-10024-1570
2-s2.0-84995972494
8942804819076392
5581364193525500
25576121
0000-0003-1781-1953
Autor
Universidade Estadual Paulista (Unesp)
Universidade do Sagrado Coração (USC)
Institución
Resumen
This paper describes a case of a rehabilitation involving Computer Aided Design/Computer Aided Manufacturing (CAD-CAM) system in implant supported and dental supported prostheses using zirconia as framework. The CAD-CAM technology has developed considerably over last few years, becoming a reality in dental practice. Among the widely used systems are the systems based on zirconia which demonstrate important physical and mechanical properties of high strength, adequate fracture toughness, biocompatibility and esthetics, and are indicated for unitary prosthetic restorations and posterior and anterior framework. All the modeling was performed by using CAD-CAM system and prostheses were cemented using resin cement best suited for each situation. The rehabilitation of the maxillary arch using zirconia framework demonstrated satisfactory esthetic and functional results after a 12-month control and revealed no biological and technical complications. This article shows the important of use technology CAD/CAM in the manufacture of dental prosthesis and implant-supported.