Artículos de revistas
Interface state contribution to the photovoltaic effect in organic phototransistors: Photocapacitance measurements and optical sensing
Fecha
2018-01-01Registro en:
Organic Electronics: physics, materials, applications, v. 52, p. 79-88.
1566-1199
10.1016/j.orgel.2017.10.010
2-s2.0-85032853699
2-s2.0-85032853699.pdf
Autor
Bangor University
Brazilian Centre of Research in Energy and Materials (CNPEM)
Universidade Estadual Paulista (Unesp)
Universidade de São Paulo (USP)
Science and Technology
Institución
Resumen
We report the results of an investigation into the contribution that trapping in interface states makes to the photovoltaic effect observed in organic phototransistors. To isolate this effect from other processes that occur in the transistor structure when under illumination, we focus attention on the photo-response of metal-insulator-semiconductor (MIS) capacitors - the core structure of transistors. The capacitors comprised poly(3-hexylthiophene), (P3HT), as the active semiconductor in combination with one of three insulators, namely, poly(amide-imide), (PAI), SU-8 photoresist and polysilsesquioxane (PSQ). Following initial characterization in the dark, the capacitor response was measured both during and after irradiation with light in the wavelength range 400–700 nm. Three different approaches were employed to study the photo-response, each providing a different insight into the processes occurring. Capacitance-voltage sweeps before, during and after illumination provided direct evidence supporting the view that the photovoltaic effect occurred as a result of electron trapping in interface states of density up to ∼2 × 1012 cm−2 in the P3HT/PAI combination but lower for SU-8 and PSQ. The dynamic photo-response, in which device capacitance was held constant by changing the applied bias, showed a fast component related to optically induced photoconduction in the semiconductor and a slower component reflecting the dynamics of interface electron trapping. Finally, photo-induced capacitance changes occurring with constant applied voltage were used to demonstrate a simple 3 × 3 imaging array.