Artículos de revistas
Effect of the diffusion of bleaching agents through enamel on dentin bonding at different depths
Registro en:
American Journal Of Dentistry. Mosher & Linder, Inc, v. 23, n. 2, n. 113, n. 115, 2010.
0894-8275
WOS:000278412500011
Autor
Lima, AF
Fonseca, FMD
Cavalcanti, AN
Aguiar, FHB
Marchi, GM
Institución
Resumen
Purpose: To evaluate the influence of two concentrations of bleaching agents applied over enamel surfaces on the dentin bonding at different depths. Methods: Twenty-four bovine incisors were sectioned, obtaining three fragments per tooth (4x4 mm). Each fragment presented a 0.7 mm enamel thickness; and the dentin thickness varied according to the experimental group: 0.5 mm, 1 mm or 1.5 mm. Fragments from each dentin-thickness were allocated into three groups (n=8): G1: Control (no bleaching); G2: 16% carbamide peroxide (6 hours/14 days); 03: 35% hydrogen peroxide (three 15-minute treatments). 24 hours after enamel bleaching, the adhesive system was applied and dentin surfaces were restored with resin composite cylinders (2 mm diameter and 1 mm height). The micro-shear testing was performed immediately after restorative procedures, at a speed of 0.5 mm/minute until failure. Bond strength values, in MPa, were statistically analyzed (split-plot ANOVA/Tukey alpha= 0.05). Results: Means obtained were: G1-0.5 mm: 13.5, G1-1 mm: 9.48, G1-1.5 mm: 9.01; G2-0.5 mm: 9.64, G2-1 mm: 9.44, G2-1.5 mm: 9.27; G3-0.5 mm: 11.68, G3-1 mm: 11.64, G3-1.5 mm: 7.63. Regardless of the dentin thickness, bleached groups presented bond strengths similar to that of control groups. Nevertheless, significant differences among dentin depths were detected (P= 0.02); and the lowest bond strength was observed on the deepest dentin (1.5 mm). The diffusion of bleaching agents through enamel surfaces did not affect the bond strength to dentin, which is highly dependent on the morphology/depth of the substrate. (Am J Dent 2010;23:113-115). 23 2 113 115