Artículos de revistas
Paper And Surface Chemistry Part Ii - Coating And Printability [papel E Química De Superfície Parte Ii - Revestimento E Printabilidade]
Registro en:
O Papel (brazil). , v. 63, n. 5, p. 75 - 83, 2002.
311057
2-s2.0-17544387057
Autor
Fardim P.
Institución
Resumen
Surface chemical interactions are important in many steps of paper manufacturing and converting. Interactions between fibres and colloidal particles, polymers, minerals and dyes are fundamental in papermaking, for example in floc formation, sizing and coating adhesion as well as in paper printability. Most papermaking interactions are complex and not very well understood, consequently, many paper formulations are designed according to an empirical trial-and-error approach. This work is a critical literature review of some interactions present in papermaking, coating and printing. In the first part of the review the interactions concerning the pulp fibres and other papermaking components in the wet-end were. In this second part the surface chemistry interactions present in coating formulation and printing are discussed. The surface engineering of paper and coating is also presented as a good potential for improving coating formulation, adhesion and paper printability. The knowledge of surface chemical interactions can be useful, not only for patents and product development, but also for improving in troubleshooting and customers support. 63 5 75 83 Alince, B., Lepoutre, P., Porosity and optical properties of clay coatings (1980) J. Coll. Interf. Sci., 76 (2), p. 439 Allem, R., Characterization of paper coatings by scanning electron microscopy and image analysis (1998) J. Pulp Pap. Sci., 24 (10), p. 329 Aspler, J.S., Interactions of ink and water with the paper surface in printing (1993) Nord. Pulp Pap. Res. J., 8 (1), p. 68 Barber, E.J., Effect of hydrocolloids on coating color operability and coated paper properties (1973) Tappi J., 56 (1), p. 52 Beghello, L., Some factors that influence fiber flocculation (1998) Nord. Pulp Pap. Res. J., 13 (4), p. 274 Berg, J.C., The importance of acid base interactions in wetting, coating, adhesion and related phenomena (1993) Nord. Pulp Pap. Res. J., 8 (1), p. 75 Chen, C.Y., Pruett, R.J., Wygant, R.W., A review of techniques for characterizing paper coating surfaces, structures and printability (1995) Proc. Tappi Coating Adv. Fund. Symp., p. 1 Dahlvik, P., (2000) Thermal thickening of paper coatings, , Tese de Doutorado, Universidade Åbo Akademi, Åbo Dahlvik, P., Ström, G., Eklund, D., Variations in calcium ion concentration and pH influencing coating colour rheology, dewatering and immobilization (1997) Nord. Pulp Pap. Res. J., 12 (1), p. 61 Diz, H.M.M., Rand, B., The variable nature of the isoelectric point of the edge surface of kaolinite (1989) Br. Ceram. Trans. J., 88, p. 162 Dollimore, D., Horridge, T.A., Dependence of flocculation behavior of china clay - Polyacrylamide suspensions on the suspensions pH (1973) J. Coll. Interf. Sci., 42 (3), p. 581 Donigian, D.W., Ishley, J.N., Wise, K., Coating pore structure and offset printed gloss (1997) Tappi J., 80 (5), p. 163 Elftonson, J., Ström, G., Penetration of aqueous solution into models for coating layers (1995) Proc. Tappi Coating Adv. Fund. Symp., p. 17 Engström, G., Morin, V., Quantitative description of the increase in surface roughness of the base paper during coating (1994) Nord. Pulp Pap. Res. J., 9 (2), p. 106 Erbil, H.Y., Calculation of spreading pressure of water on cellulosic films from contact angle data (1997) Turkey J. Chem., 21, p. 332 Eriksson, U., Rigdahl, M., Dewatering of coating colors containing CMC or starch (1994) J. Pulp Pap Sci., 20 (11), p. 333 Evans, D.F., Wennerström, H., (1999) The colloidal domain, where physics, chemistry, biology and technology meet, p. 426. , Willey, New York Fadat, G., Rigdahl, M., Interactions in coating colors Part 2. Effects of ionic strength (1986) Nord. Pulp Pap. Res. J., 1 (4), p. 37 Fardim, P., (1999) Composição química da superfície da polpa kraft de eucalyptus: Caracterização e influências nas propriedades físicas e físico-químicas das fibras, , Tese de Doutorado. Instituto de Química, Universidade Estadual de Campinas, UNICAMP Gane, P.A.C., Waters, P., McGenity, P., Factors influencing the runnability of coating colors at high speed (1992) Proc. Tappi Coating Conf., p. 117 Granier, V.V., Sartre, A., Joanicot, M.M., Adhesion of latex particles on inorganic surfaces (1994) Tappi J., 77 (5), p. 419 Grön, J., Eklund, D., Temperature effect on rheological and dewatering properties for starch-based coating colors (1998) Nord. Pulp Pap. Res. J., 13 (1), p. 10 Grön, J., Kuni, S., The impact of different coating pigments and molecular weight of carboxymethyl cellulose on coating structure (1995) Proc. Tappi Coating Conf., p. 447 Grön, J., Dahlvik, P., Ström, G., Influence of starch modification on the chemical composition and structure of coated layers (1998) Nord. Pulp Pap, Res. J., 13 (2), p. 119 Grön, J., (1998) Coating suspension structure and rheology, , Tese de Doutorado, Universidade Åbo Akademi, Åbo Israelachvili, J., 1996Joanicot, M., Wong, K., Cabane, B., Structure of latex films (1993) Proc. Tappi Coating Conf., p. 383 Kline, J.E., Fundamental aspects of latex mobility in paper coatings (1993) Proc. Tappi Adv. Coating Fund. Symp., p. 93 Krieger, I.M., Dougherty, T.J., A mechanism for non-Newtonian flow in suspensions of rigid spheres (1957) Trans. Soc. Rheol., 3, p. 137 Lepoutre, P., Lord, D., Desestabilized clay suspensions: Flow curves and dry film properties (1990) J. Coll. Interf. Sci., 134 (1), p. 66 Malik, J.S., Kline, J.E., A study of the effect of water soluble polymers on water holding and binder migration tendencies of coatings (1992) Proc. Tappi Coating Conf., p. 105 McGenity, P.M., Gane, P.A.C., Husband, J.C., Engley, M.S., Effect of interactions between coating color components on rheology, water retention and runnability (1992) Proc. Tappi Coating Conf., p. 133 Perry, S.S., Somorjai, G.A., Characterization of organic surfaces (1994) Anal. Chem., 63 (7), p. 403 Rand, B., Melton, I.E., Particle interactions in aqueous kaolinite suspensions 1. Effect of pH and electrolyte upon the mode of particle interaction in homoionic sodium kaolinite suspensions (1977) J. Coll. Interf. Sci., 60 (2), p. 308 Reinbold, I., Ulrich, H., Possibilities and limitations of high solids coating colors (1979) Proc. Tappi Coaling Conf., p. 31 Sanders, N.D., The effect of surface modification of pigments on colloidal stability and structural performance (1992) J. Pulp Pap. Sci., 18 (5), p. 169 Sandås, S., Salminen, P., Pigment-co binder interactions and their impact on coating rheology, dewatering and performance (1991) Tappi J., 74 (12), p. 179 Schramm, G., (1994) A practical approach to rheology and rheometry, , Haake GmbH Publication, Karlsruhe Scott, W.E., Abbott, J.C., Trosset, S., (1995) Properties of paper: An introduction, p. 161. , Tappi Press, Atlanta Shaw, D.J., (1980) Introduction to colloid and surface chemistry, p. 208. , Butterworth, Londres Stenius, P., Järnström, L., Rigdahl, M., Aggregation in concentrated kaolin suspensions stabilized by poiyacrylate (1990) Coll. Surf., 51, p. 219 Ström, G., Härdin, A.-M., Salminen, P., A novel approach for improving fibre coverage during blade coating (1995) Nord. Pulp Pap. Res. J., 10 (4), p. 227 Swerin, A., (1995) Flocculation and fiber network strength in papermaking suspensions flocculated by retention aids systems, , Tese de Doutorado. Royal Institute of Technology, Estolcomo Van Gilder, R.L., Purfeerst, R.D., The effect of coating color solids on properties and surface uniformity (1986) Tappi J., 69 (5), p. 119 Verhoeff, J., Hart, J.A., Gallay, W., Sizing and the mechanism of penetration of water into paper (1963) Pulp Pap. Mag. Can., 64, pp. T509 Wang, X.Q., Grön, J., Eklund, D., Temperature dependence for adsorption of carboxymethyl cellulose on clay (1996) Proc. Tappi Coating Conf., p. 79 Whalen-Shaw, M., Gautam, N., A model for colloidal and rheological characteristics of kaolin latex NaCMC formulations (1990) Proc. Tappi Coating Conf., p. 371 Whalen-Shaw, M., Coating structure - Part I: A mechanistic view to the development of wet coating structure (1989) Proc. Tappi Coating Conf., p. 9 Wickman, M., (1998) Surface chemical behavior of alkyd resins in offset printing inks, , Tese de Doutorado. Royal Instute of Technology, Estolcomo Young, T.S., Fu, E., Associative behavior of cellulosic thickeners and its implications on coating structure and rheology (1991) Tappi J., 74 (4), p. 197 Zang, Y.-H., Aspler, J.S., The effect of surface binder content on print density and ink receptivity of coated paper (1998) J. Pulp Pap. Sci., 24 (5), p. 141