Autor
Laines Canepa, José Ramón
Adams Schroeder, Randy Howard
Resumen
The only alternative for the final disposal of solid wastes in Mexico is the sanitary landfill, but the leachate generated represents a water and soil contamination risk. This work had the purpose of determining the coagulation-flocculation potential of several mixtures made up of variable proportions of banana starch, aluminum sulfate and clays (LASA 55; LASA 73; LASAB 23530 and LASAR 23530). To evaluate the coagulation-flocculation effectiveness, controls were run with aluminum sulfate and ferric chloride. Leachate was pretreated and jar tests were performed, measuring control components as Turbidity, Color, Chemical Oxygen Demand (COD) Hydrogen Potential (pH), Total Suspended Solids (TSS) and Conductivity. Turbidity was reduced to less than 5 NTU with 75 mg/L in two treatments (LASA 55 and aluminum sulfate). The highest color removal was obtained with ferric chloride, followed by LASA 55 and aluminum sulfate, LASAB 23530 and LASA 73, the lowest being that with LASAR 23530. The mixtures based on starch plus aluminum sulfate showed a low COD removal and, in comparison with LASAR, the conventional coagulants presented a better removal. A very similar correlation was observed between TSS and conductivity. The results obtained in this work determined the feasibility of applying mixtures with coagulant properties for leachate treatment and for future tests in the treatment of industrial or municipal wastewaters.
Un problema en México, es el manejo inadecuado de residuos sólidos, una alternativa es el relleno sanitario. El lixiviado generado representa riesgo de contaminación de agua y suelo. El objetivo, fue probar el potencial de coagulación-floculación de diversas mezclas formadas con proporciones variables de almidón de plátano, Sulfato de aluminio y arcillas (LASA 55; LASA 73; LASAB 23530 y LASAR 23530). Para evaluar la efectividad de coagulación-floculación se corrieron testigos de coagulación con Sulfato de aluminio y Cloruro Férrico. Se pretrató el lixiviado, y se desarrollaron pruebas de jarras. Se midieron componentes de control: Turbiedad, Color, Demanda Química de Oxígeno (DQO), potencial de Hidrógeno (pH), Sólidos Suspendidos Totales (SST) y Conductividad. Se redujo la turbiedad a menos de 5 UNT con 75 mg/L, en dos tratamientos (LASA 55 y Sulfato de aluminio). La mejor remoción de color fue la obtenida con el Cloruro férrico, seguidas por LASA 55 y el Sulfato de aluminio, LASAB 23530 y LASA 73, la peor fue LASAR 23530. Las mezclas basadas en almidón más Sulfato de aluminio efectuaron un papel pobre de remoción de DQO; a diferencia de LASAR, los coagulantes convencionales presentaron mejor remoción. En cuanto a los SST y Conductividad se observa una correlación muy similar entre ambas. Los resultados obtenidos en el presente trabajo, permitieron establecer la factibilidad de aplicar mezclas con propiedades coagulantes para el tratamiento de lixiviados o bajo pruebas futuras, en el tratamiento de aguas residuales industriales o municipales.