Buscar
Mostrando ítems 31-40 de 1473
Mechanical behavior of different restorative materials and onlay preparation designs in endodontically treated molars
(2021-04-02)
This study evaluated the effect of the combination of three different onlay preparation designs and two restorative materials on the stress distribution, using 3D‐finite element analysis. Six models of first lower molars ...
Stress distribution in bone simulation model with pre-angled implants
(Taylor & Francis, 2015)
The aim of this study was evaluate the biomechanical behaviour of prostheses screwed into conventional (0° angulation) and pre-angled experimental (8, 12 and 20°) external hexagon implants (13 × 4 mm) by photoelastic ...
Analysis of the biomechanical behavior of short implants: the photo-elasticity method
(Elsevier B. V., 2015-10-01)
The aim of this study was to analyze the stress distribution of short implants supporting single unit or splinted crowns by the photo-elasticity method. Four photo-elastic models were produced: A (3.75×7mm); B (3.75×7mm, ...
Three-dimensional finite element analysis of stress distribution in retention screws of different crown-implant ratios
(2013-08-21)
The retaining screw of the implant-supported dental prosthesis is the weakest point of the crown/implant system. Furthermore, crown height is another important factor that may increase the lever arm. Therefore, the aim of ...
Three-dimensional finite element analysis of stress distribution in retention screws of different crown-implant ratios
(2013-08-21)
The retaining screw of the implant-supported dental prosthesis is the weakest point of the crown/implant system. Furthermore, crown height is another important factor that may increase the lever arm. Therefore, the aim of ...
Influence of the implant diameter with different sizes of hexagon: Analysis by 3-dimensional finite element method
(2013-08-01)
The aim of this study was to evaluate the stress distribution in implants of regular platforms and of wide diameter with different sizes of hexagon by the 3-dimensional finite element method. We used simulated 3-dimensional ...
Influence of the implant diameter with different sizes of hexagon: Analysis by 3-dimensional finite element method
(2013-08-01)
The aim of this study was to evaluate the stress distribution in implants of regular platforms and of wide diameter with different sizes of hexagon by the 3-dimensional finite element method. We used simulated 3-dimensional ...