Buscar
Mostrando ítems 1-10 de 17072
Review on Generation and Characterization of Copper Particles and Copper Composites Prepared by Mechanical Milling on a Lab-Scale
(2023)
This review aims to expose mechanical milling as an alternative method for generating copper-based particles (copper particles (CuP) and copper composites (CuC)); more specifically, via a top-down or bottom-up approach, ...
Trinidad Old Mill
(2010-03-31)
Photo of a mill building located in Trinidad. Outside is a horse and the card is stamped "Ethel H. Traphagen".
Modelling SAG milling power and specific energy consumption including the feed percentage of intermediate size particles
(Elsevier, 2015)
Comminution, particularly milling, is on average the largest consumer of energy in mining. Actual comminution circuits consist in most of the cases in coarse crushing, SAG milling, pebble crushing and secondary ball milling. ...
Mechanochemical synthesis of PZT powders
(Elsevier B.V., 2003-03-25)
PZT ceramic powders were successfully prepared from the mixture of PbO, ZrO2 and TiO2 by mechanochemical synthesis in a planetary ball mill, under different milling conditions. Phase evolution during synthesis was monitored ...
Effect of ball milling strategy (milling device for scaling-up) on the hydrolysis performance of Mg alloy waste
(Pergamon-Elsevier Science Ltd, 2020-08)
Ball milling strategy is of prime importance on the hydrolysis performance of Mg alloy waste. The effect of milling device (e.g. Fritsch Pulverisette 6 (P6) and Australian Uni-Ball-II (UB)), milling atmosphere (H2 and Ar), ...
Use of high energy ball milling on the sintering optimization of alumina ceramics
(2010-12-15)
In this work, the effect of the milling time on the densification of the alumina ceramics with or without 5wt.%Y 2O 3, is evaluated, using high-energy ball milling. The milling was performed with different times of 0, 2, ...
Use of high energy ball milling on the sintering optimization of alumina ceramics
(2010-12-15)
In this work, the effect of the milling time on the densification of the alumina ceramics with or without 5wt.%Y 2O 3, is evaluated, using high-energy ball milling. The milling was performed with different times of 0, 2, ...
Analysis of the cutting forces in plunge milling
(Sage Publications LtdLondonInglaterra, 2013)