Buscar
Mostrando ítems 1-10 de 36
Vibration and wear particles analysis in a test stand
(2007-08-17)
Purpose - This paper aims to provide information on wear debris on oil and vibration analysis as predictive maintenance techniques. Design/methodology/ approach - The estate of a reducer is verified by analyzing the vibration ...
Wear Particle Classifier System Based on an Artificial Neural Network
(Assoc Mechanical Engineers Technicians Slovenia, 2010-04-01)
This paper describes a method of identifying morphological attributes that classify wear particles in relation to the wear process from which they originate and permit the automatic identification without human expertise. ...
Maintenance of a reducer by vibration and wear particles analysis
(2006-06-20)
Purpose - The purpose of the paper is to provide information on wear debris on oil and vibration analysis as predictive maintenance techniques in reducer. Design/methodology/approach - The estate of a reducer is verified ...
A mechatronic system applied to wear particle analysis
(2008-12-01)
This paper describes the development of a mechatronic system for a predictive maintenance grounded on wear particle analysis. The reckoning of wear particles containing in lubricating industrial oils brings the image ...
Wear behavior of AA1060 reinforced with alumina under different loads
(Elsevier Science Sa, 2009-01)
The wear behavior of samples of AA1060 aluminum matrix reinforced with 15 vol% of alumina particles in a range of loads between 4.9 and 91.2 N was determined using a pin-on-ring machine at a velocity of 2.7 m/s. The ...
Friction coefficient and abrasive wear modes in ball-cratering tests conducted at constant normal force and constant pressure-Preliminary results
(ELSEVIER SCIENCE SA, 2009)
The micro-scale abrasive wear test by rotative ball has gained large acceptance in universities and research centers, being widely used in studies on the abrasive wear of materials. Two wear modes are usually observed in ...
Planning and construction of mechanism for surface wear testing and fault analysis in quadril joint prosthetic tribosystem
(2020-02-01)
The problems associated with prosthetic failures and revision surgeries have increased greatly since total joint replacement has also been applied to younger and more active patients, so the need to resolve or reduce ...
Surface Damage On Dental Implants With Release Of Loose Particles After Insertion Into Bone
(WILEY-BLACKWELLHOBOKEN, 2015)
Mass loss and wear mechanisms of HVOF-sprayed multi-component white cast iron coatings
(ELSEVIER SCIENCE SALAUSANNE, 2012)
In this work, multi-component white cast iron was applied by HVOF thermal spray process as alternative to other manufacture processes. Effects of substrate type, substrate pre-heating and heat treatment of coating on mass ...
Wear Behavior of Ti-Al2O3 Biocomposites in 9 g/L NaCl Solution
(2019-10-01)
Ti-based biocomposites reinforced with Al2O3 particles were processed by powder metallurgy. Wear behavior was investigated by reciprocating wear tests in 9 g/L NaCl solution. The effect of Al2O3 volume fraction, normal ...