Now showing items 1-10 of 2393
Effect of thermal treatments on tensile strength of commercially cast pure titanium and Ti-6Al-4V alloys
Heating titanium structures is assumed to relieve tensions induced by the casting process as well as possibly optimizing some mechanical properties. The aim of this investigation was to evaluate the effect of thermal ...
TENSILE AND CREEP BEHAVIOR OF GEOSYNTHETICS USING CONFINED-ACCELERATED TESTS
(IOS Press, 2013-01-01)
A major aspect in geosynthetics creep analysis is the load level applied to the specimen, usually referred as a percentage of the geosynthetic ultimate tensile strength (UTS). Since both tensile and creep standard tests ...
Carbon Fiber Reinforced Polymer and Epoxy Adhesive Tensile Test Failure Analysis Using Scanning Electron Microscopy
(Univ Fed Sao Carlos, Dept Engenharia Materials, 2017-07-01)
Morphological characteristics analysis before and after tensile tests were studied using scanning electron microscopy (SEM) technique to follow the failure evolution on carbon fiber reinforced polymer (CFRP) and epoxy ...
Tensile bond strengths of hard chairside reline resins as influenced by water storage
Due to gradual resorption of the edentulous ridge bone, removable prostheses often require denture base relines to improve fit and stability. This research evaluated the bond strength between one heat-cured acrylic resin ...
Orthodontic brackets removal under shear and tensile bond strength resistance tests - a comparative test between light sources
(Wiley-v C H Verlag Gmbh, 2008-01-01)
We have investigated if a new LEDs system has enough efficient energy to promote efficient shear and tensile bonding strength resistance under standardized tests. LEDs 470 +/- 10 nm can be used to photocure composite during ...
Determining the tensile stress-crack opening curve of concrete by inverse analysis
(Asce-amer Soc Civil EngineersRestonEUA, 2006)
Diametral tensile strength of dual-curing resin cements submitted exclusively to autopolymerization.
OBJECTIVES: To evaluate, at different times, the diametral tensile strength (DTS) of dual-curing resin cements that were not photopolymerized. METHOD AND MATERIALS: Equal amounts of base and catalyst pastes of Panavia F ...
Equivalence between hot tensile and creep testing data for Kanthal A1 alloy
(ESCOLA DE MINAS, 2011)
Hot tensile and creep tests were carried out on Kanthal A1 alloy in the temperature range from 600 to 800 degrees C. Each of these sets of data were analyzed separately according to their own methodologies, but an attempt ...