In this work, the changes to stereolithography (SL) resin mechanical properties during the injection moulding process were evaluated. A multi-impression SL mould was built and used to inject a series of small flat mouldings. ...

The effect of water immersion on the morphology and indentation modulus of injection moulded nylon 6 and its organoclay nanocomposites was investigated. XRD analysis showed that at 70 °C water promoted further crystallization ...

The fracture performance of PP–nanoclay box-like injection mouldings obtained in double gated mould and by direct compounding of PP and a PP-based masterbatch was studied. Samples were observed by polarised light microscopy ...

In this work, the changes to stereolithography (SL) resin mechanical properties during the injection moulding process were evaluated. A multi-impression SL mould was built and used to inject a series of small flat mouldings. ...

A nanoclay based masterbatch was mixed with polypropylene and direct injection moulded by conventional (CIM) and shear controlled orientation (SCORIM) injection moulding techniques. The aim was to correlate the morphologies ...

A nanoclay based masterbatch was mixed with polypropylene (PP) and injection moulded by conventional (CIM) and shear controlled orientation (SCORIM) injection moulding techniques. The aim was to correlate the morphologies ...

Injection moldings with weld lines were produced in glass reinforced polypropylene grades differing in filler content using a two-gated hot runner injection mold. The skin-core microstructure developed during injection ...

Plastic injection moulds suffer wear due to the relative movements of the mould parts and the polymeric material flow which is often reinforced by hard abrasive fibres or whiskers. Several studies were performed on the ...