Buscar
Mostrando ítems 81-90 de 2447
Stability analysis of multi-degree of freedom systems in milling operations: Altintas analytical method vs. chebyshev polynomial approximation-Edición Única
(Instituto Tecnológico y de Estudios Superiores de Monterrey, 2006-12-01)
Chatter phenomena, essentially known as forced and self excited (regenerative)
vibration, has long been a problem in machining operations. Many approaches
trend to predict the limits of stable zones based on predictive ...
Tuning of the dynamic model of a Linear Permanent Magnet Synchronous Motor in a positioning machine for metrology processes
In this thesis, it is studied a dynamic force model for a Linear Permanent Magnet Synchronous Motor. A first approach to use the force model as a part of a Digital Twin is studied. The modeling was made from a machine ...
Influence of design parameters on linear induction motor end effect
(Institute of Electrical and Electronics Engineers (IEEE), 2008-06-01)
In this paper, a factor referred to as k(f) for linear induction motor end effect analysis is presented. The mathematical model takes into account the longitudinal entry end effect. The entry end effect produces considerable ...
Influence of design parameters on linear induction motor end effect
(Institute of Electrical and Electronics Engineers (IEEE), 2008-06-01)
In this paper, a factor referred to as k(f) for linear induction motor end effect analysis is presented. The mathematical model takes into account the longitudinal entry end effect. The entry end effect produces considerable ...
Effect of gel chemistry on the machinability of green SiC parts produced by gelcasting
(2012)
The growing interesting in the use of silicon carbide in automotive components, biomaterials, energy, among others, which demand the production of parts with complex geometry that are difficult to obtain by conventional ...
Análise do acabamento superficial e força de corte no torneamento de alumina a verde
(Univ Fed Rio De Janeiro, Lab Hidrogenio, 2015-04-01)
In experimental conditions, cutting forces were studied during turning of green alumina billets, including their correlation with surface aspects of the workpiece. The correlation between cutting power and the removal rate ...