Buscar
Mostrando ítems 11-20 de 68
Modelado y simulación numérico-matemático de parámetros de funcionamiento para un vehículo eléctrico en la ciudad de Cuenca-Ecuador
(2017)
In a driving cycle estabilished to achieve an approximation of an electric vehicle's autonomy availability, a tool has been developed for the behavior of an electric vehicle based on operating parameters configuration, ...
Análisis estructural mediante el método de elementos finitos del chasis del vehículo formula SAE eléctrico de la Universidad Politécnica Salesiana. Cuenca 2017
(2017)
Our work was oriented to perform a static analysis of the formula SAE chassis of the Salesian Polytechnic University, simulation software was used to determine the maximum deformations and stresses, the results were validated ...
Obtención del modelo dinámico de un motor trifásico de inducción utilizando técnicas de identificación de sistemas con lógica difusa
(2016)
In this research and development project is presented the obtaining of the dynamic model of a three-phase induction motor using techniques of identification of systems with fuzzy logic. The three-phase induction machine ...
Metodología para la viabilidad del uso de aerogeneradores sobre edificaciones en zonas urbanas de la ciudad de Cuenca aplicando análisis en CFD
(2023)
The use of wind power for electricity generation in urban areas is limited by resource availability, wind potential, turbulence between buildings, and technologies, etc. In this study was to develop a methodology for the ...
El impacto del uso de los simuladores en el proceso de la enseñanza – aprendizaje de la asignatura de física en educación general básica.
(2023)
The use of simulators by teachers generates a positive impact on the quality of teaching and learning. These are pedagogical tools that allow the creation of complex and controlled situations for students to safely experiment ...
Validación computacional de vertederos rectangulares y triangulares para generar un modelo nuevo triangular asimétrico que facilitaría la medición de las cargas en estructuras hidráulicas
(2017)
In the present research project, the relationship between flow and water level in an asymmetric thin-walled triangular-shaped landfill was determined by a computational simulation model instead of the use of conventional ...
Diseño de un sistema inteligente que permita estimar y simular la autonomía de un vehículo eléctrico en rutas urbanas de la ciudad de Cuenca
(2017)
This project is aimed to design an intelligent system that estimate and simulate the autonomy of an electric vehicle. The system needs eight variables to calculate the autonomy of the vehicle; to acquire the data to be ...
Simulación por ordenador mediante el método de elementos finitos y optimización por el método de ingeniería robusta, de conectores para estantería metálica
(2015)
The research is about the analysis, simulation and optimization of connector metal shelving, it serves to engage and transmit the load to the vertical profiles stored material. The objective is to obtain a better design ...
Diseño y simulación de un diagnosticador de fallas en sensores y actuadores usando un enfoque descentralizado para un sistema de bandas transportadoras de productos
(2017)
An analysis is performed on a system of product transport belts, using the criterion of finite state automata, to propose the verification of failures. Modeling the plant and controller, deduces the diagnostician. Failure ...
Segmentación de imágenes de frutos de café utilizando información de textura y descriptores de forma
(Universidad del NorteMaestría en Ingeniería ElectrónicaDepartamento de Ingeniería Electrónica, 2019)